Stimmen - 7, Durchschnittliche Bewertung: 3.4
(
)
)
|
Anleitung Zusammenfassung
Make sure that the hose is not folded over or bent. ! The water pressure at the tap must fall within the values indicated in the Technical data table (see next page). ! If the inlet hose is not long enough, contact a specialised shop or an authorised technician. ! Never use second-hand or old inlet hoses; use the products supplied with the machine. 2 Connecting the drain hose Connect the drain hose to drain duct piping or a wall drain located between 65 and 100 cm above the floor, making sure it is not bent at all. ! Do not use extension cords or multiple sockets. ! The cable should not be bent or compressed. ! The power supply cable and plug must only be replaced by authorised technicians. Warning! The company shall not be held responsible in the event that these regulations are not respected. E Alternatively, rest the drain hose on the side of a washbasin or bathtub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater. ! We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length. Electrical connections Before plugging the appliance into the electricity socket, make sure that: • the socket is earthed and complies with all applicable laws; • the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table (see opposite); • the power supply voltage falls within the values indicated in the Technical data table (see opposite); • the socket is compatible with the plug of the appliance. If this is not the case, have the socket or the plug replaced. ! The appliace must only be installed indoor in a frost free and dry room, to prevent it from electronic damage due to frost or condensation. ! The mains socket must remain within easy reach after the washing machine has been installed. Technical data Model AQ7L 093 X Dimensions width 59.5 cm height 85 cm depth 64,5 cm Capacity from 1 to 7 kg Electrical connections please refer to the technical data plate fixed to the machine Water connections maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.5 bar) drum capacity 62 litres Spin speed up to 1000 rotations per minute Test Programmes according to 2010/1061 programme '¡ff; temperature 60°C and 40°C. Test Programmes according to EN 60456 ® (R^ (TR) programme tjsj3; temperature 60°C; using a load of 7 kg. (€ X This appliance conforms to the following EC Directives: - 2004/108/EC (Electromagnetic Compatibility) - 2006/95/EC (Low Voltage) - 2002/96/EC 3 Description of the machine ADJUSTABLE FEET PORTHOLE DOOR The detergent dispenser drawer is located inside the machine and can be accessed by opening the door. For more information on detergent measures, please refer to the chapter entitled “Detergents and laundry”. Note: stick the label showing the wash cycle descriptions and options on the front of the detergent dispenser drawer. You will find the sticker in the pack containing this manual. 1. pre-wash compartment: use powder detergent. ! Before pouring in the detergent, make sure that extra compartment 3 has been removed. 2. main wash compartment: use powder or liquid detergent. If using the latter type of detergent, we recommend it is poured into the drawer immediately before you start the washing machine. 3. extra compartment: Bleach ! The use of extra compartment 3 excludes the prewash function. £§> washing additives compartment: for fabric softener or liquid additives. We recommend that the maximum level indicated by the grille is not exceeded, and that concentrated fabric softeners are diluted. Standby mode This washing machine, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF © button briefly and wait for the machine to start up again. 4 Control panel WASH CYCLE SELECTOR knob Button with ON/OFF indicator light SPIN indicator lights TEMPERATURE indicator lights OPTION buttons with indicator lights DELAYED START indicator lights ECO indicator light WASH CYCLE PHASE OPTION buttons with | indicator lights START/PAUSE button with indicator light TEMPERATURE button SPIN button DELAYED START button DOOR LOCKED indicator light CONTROL PANEL LOCK button with indicator light E Button with © ON/OFF indicator light: press this briefly to switch the machine on or off. The green indicator light indicates that the machine is switched on. To switch off the washing machine during the wash cycle, press and hold the button for approximately 3 seconds; if the button is pressed briefly or accidentally the machine will not switch off. If the machine is switched off during a wash cycle, this wash cycle will be cancelled. WASH CYCLE SELECTOR knob: may be turned in either direction. To select the most suitable wash cy...