Stimmen - , Durchschnittliche Bewertung:
(
)
)
Hersteller: Equator
Dateigröße: 3.74 mb
Dateiname: af967189-ed81-4cdc-a050-7138612f11ef.pdf
Unterrichtssprache:
Das Dokument wird geladen, bitte warten
 |
Das Dokument wird geladen, bitte warten
Anleitung Zusammenfassung
Take clothes out and within a few minutes they will be dry. Do not overdry the clothes. 5. USE LOW SUDSING DETERGENT: By using low sudsing detergent (Equator brand or any other), you are preventing suds from entering the condensing chamber. When suds enter the condensing chamber, lint particles can clog up the chamber and the fan blower. Over time, this reduces drying efficiency and may require the fan blower (impeller) to be cleaned. Instructions for installation and use 4 Safety Equator Appliances is proud to offer our customers products with the ENERGY STAR label. INTRODUCTION Your new appliance is carefully engineered product. Many times Your Washer-Dryer is front loading, with an extra large door what appears to be a reason to call for service, requires nothing opening for easier access. It has 9 wash cycles in addition more than a simple adjustment you can easily make in your to extra rinse and pre wash cycles. own home. You will be charged for a service call while the appliance You will obviously want to obtain the best possible wash. By is in warranty if the problem is not caused by defective reading and following the instructions in this booklet you will product workmanship or materials covered by this achieve excellent results. warranty. To avoid a charge for an unnecessary service call, and before Please, ensure that the instructions are followed. If you shouldcalling a serviceman, please refer to the troubleshooting section need any further advice or assistance, please, contact thefor situations that you can remedy. This section is included on dealer where your machine was purchased, or call Equatorpages 16-17 of this Use and Care Book. Customer Service at 1-800-776-3538. This appliance is an automatic washer with a capacity of up to: -WASH 14 Lbs -WASH & DRYING 10 Lbs dry weight of clothes PRE-INSTALLATION 1. The washer must be installed on a strong level floor, and in 3. Dryer installation and grounding should be done in protected, dry, and well-ventilated area close to a power and accordance with local codes by a qualified installer. water supply of sufficient capacity, and a sufficient outlet. “Installation Instructions” are included in your Use and Care manual for the Installer’ s reference. 2. Installation on Carpet or Wood increases vibrations. • Carpets - place on light carpet only. 4. The washer should be plugged into a properly grounded • Wood - brace floor with screws and place additional sheets three (3) prong electrical outlet of 120 Volt, 1300 W, 13 A, of plywood before installation. 60 Hz. It should not be controlled by a wall switch or pull cord which might be turned off accidentally. 5 Instructions for installation and use Installation When the new washer-dryer arrives Whether new or just transported to a new house, installation is extremely important for the correct functioning of your washer-dryer. After removing the appliance from its packaging, check that it is intact. If in doubt, contact Equator immediately. The inside of the machine is supported, for transportation, by four shipping bolts on the back panel. Before using the washer-dryer, remove the external shipping bolts, remove the spacers together with the rubber tubes attached to them (save all the parts) and use the plastic blanking plugs provided to fill in the holes. Use the wrench provided to remove the external bolts. Attach the two rubber hoses provided to the red (hot) and white (cold) water inlets on the back (top right) or the appliance. Connect the other ends to the appropriate built-in water supplies or a Y-adapter / Faucet Adapter combination to a single source (like a kitchen faucet.). Using the “U”-Connector provided, place the drain hose into the drain pipe (or the sink.) See Plumbing on Pg. 7 for more details. Leveling The washer-dryer must be levelled appropriately in order to guarantee its correct functioning. To level the appliance, the front feet must be adjusted; the angle of inclination, measured according to the worktop, must not exceed 2°. WARNING ! Excessive Weight Hazard Use two or more people to move and install your appliance. Failure to do so can result in back or other injury The front feet are self-locking & adjustable WARNING ! Electrical Requirements Electrical Shock Hazard (death, fire or electrical shock): 1) Plug into a grounded 3 prong outlet. 2) Do not remove ground prong. 3) Do not use an adapter or an extension cord. Retain the shipping bolts, spacers and washers. Should you move residence then these should be replaced to support the inside of the machine to prevent damage when transporting the machine. For your own protection, and to prevent accidents, injury and fire, please read the following carefully: 1. Destroy the carton and plastic bags, after the washer-dryer has been unpacked. 2. Children should never be left alone or unattended in the area where appliances are located. 3. Washer installation and grounding must be done in accordance with local codes by a qualified inst...