Anleitung Alliance Laundry Systems, modell WD1035
Hersteller: Alliance Laundry Systems Dateigröße: 2.06 mb Dateiname: 756437c4-e16c-ee84-8996-c5c89dbf871c.pdf
Unterrichtssprache:
|
|
|
|
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite
Anleitung Zusammenfassung
This booklet not only tells you howto operate your new Electrolux automatic washing machine, but also contains a number of helpful tips on how to get the best results. SO PLEASE READ IT THROUGH CAREFULLY BEFORE YOUR FIRST WASH. IT ALSO INCLUDES AN IMPORTANT CHECKLIST OF WHAT TO DO SHOULD A FAULT OCCUR, PLUS A LIST OF ELECTROLUX SERVICE OFFICES WHERE SERVICE CAN BE OBTAINED IF NEEDED. Before requesting service please check whether your problem is covered on page 20 under ‘Servicing’ and that you are operating the machine according to the instructions. If our engineer finds that the problem is due to misuse or incorrect installation you may be charged for his visit even though your machine is under guarantee. 00 HI f ;Ti5> Page 3 Specifications. 4 About your Washer Dryer. 6 Electrical Information. 7-8 The Controls and how to use them. 9-12 The Programmes. 13-15 Using your Machine. 16 Drying. 17 Looking after your Machine. 18-19 Helpful tips. 20 Servicing. 22 Guarantee. 2 Specifications Dimensions Height 850mm 33.5" Width 600mm 23.6" Depth 600mm 23.6" Weight 90kg 1981b Capacity for wash 4.5 kg 101b Capacity for drying 2.25kg 51b Revolutions per minute 500/1000 Total power 2500W Heater rating (wash) 2300W Heater rating (drying) 1350W Motor ratisng Wash 200W Spin 400/550W Voltage 220/240V Frequency 50Hz Water load Normal 13 litres 2.9 gallons High 20 litres 4.4 gallons Pressure p%l Maximum 110 Minimum (hot) 4 Minimum (cold) 7 3 About your washer dryer Your new Electrolux washer dryer has a selection of programmes to suit all your washing and drying needs. This booklet not only tells you how to operate your new washer dryer, but also contains a number of helpful tips on how to get the best results. SO PLEASE READ IT THROUGH CAREFULLY BEFORE USING THE MACHINE. It also includes an important checklist of what to do should a fault occur, plus a list of the Electrolux service offices where service can be obtained if it is needed. Before requesting service please check whether your problem is covered on page 20 under “Servicing” and that you are operating the machine according to the instructions. If the engineer finds that the problem is due to misuse or incorrect installation you may be charged for his visit, even though your machine is under guarantee. CO Programme Selector Dial and On/Off W Control © Drying Time Control (zÿ Door Release Button ^4^ Half Load/Autodry Facility Button Delicate Dry Button © Detergent Dispenser © Programme Guide © Delay Start Timer © Pump Filter (behind lower panel) 4 Electrical information Connecting to the mains Before you use your washer dryer check that the voltage shown on the data plate conforms with your mains supply. The mains lead of the washer dryer is fitted with a non-rewireable moulded-on 13 amp plug containing a 13 amp fuse. In the event of the fuse requiring replacement, the fuse cover/carrier should be removed, using a small screw driver to lever it out. The old fuse should be replaced by a 13 amp ASTA approved BS1362 fuse and the fuse cover/carrier must be refitted before the plug is used again. If the fuse cover/carrier is lost, a replacement can be obtained from the Electrolux Service Shops and offices listed on page 21. The fuse cover/carrier must be of the same colour as that of the coloured insert in the base of the plug. In no circumstances must the plug be used without a correct fuse cover/carrier fitted. If the plug supplied on the mains lead is not suitable for the socket outlet in your home it should be cut off and disposed of safely, or destroyed, to avoid any possible shock hazard resulting from the plug being inserted into a 13 amp socket elsewhere in the house. A suitable replacement plug should befitted (as in Fig. 1). If a 13 amp plug and socket are not used, the circuit supplying the washing machine should contain a 15 amp fuse. WARNING - THIS APPLIANCE MUST BE EARTHED. IMPORTANT The wires in the mains lead of this appliance are coloured in accordance with the following code:- GREEN-and-YELLOW: EARTH BLUE :NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- Connect the GREEN-and-YELLOW coloured wire to the plug terminal marked letter E or earth symbol^or coloured green or green-and-yellow. Connect the BROWN coloured wire to the plug terminal marked letter L or coloured red. Connect the BLUE coloured wire to the plug terminal marked letter N or coloured black. 6 The controls and how to use them 1. Programme Selector dial and on/off control The selector dial is marked with letters corresponding to those on the programme guide. To set the machine to the correct programme (see programme guide and table on pages 9-12) press in the central grip to engage the dial and turn clockwise until the letter you want coincides exactly with the pointer. Never...