Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
The DISH 500 mode, in which the SAT SELECT button switches between the two DISH 500 satellites, has been changed to make it easier to use. The following instructions have been updated to reflect this change. 3.5 DISH 500 Operation The DISH 500 service offers programming on two different satellites (Echo 119 and 110). To easily switch between these two satellites, you will need to configure the system for DISH 500 mode, in which the SAT SELECT button selects between just the Echo 119 and 110 satellites. 3.5.1 Configuring the System for DISH 500 Mode To configure the TracVision system for DISH 500, follow the steps below. 1. Turn on your receiver, TV, and TracVision system. 2. Using the receiver’s remote control, go to the “Point Dish/Signal Strength” screen (press MENU, 6, 1, 1 (on most models)) and select satellite 119 and transponder 11. 3. When the switchplate’s Status indicator fully illuminates (stops flashing), check the signal strength meter on the TV. If the meter turns green and indicates “Locked–Echostar 119,” skip to step 6. NETWORK 54-0194 Addendum to Rev.D 4. Press the switchplate’s SAT SELECT button for 1 second. When you release the button, the Status indicator starts flashing while the antenna searches for another satellite. 5. When the switchplate’s Status indicator fully illuminates again, check the signal strength meter. If the meter turns green and indicates “Locked– Echostar 119,” proceed to step 6. If the meter stays red, repeat step 4. 6. Press and hold the SAT SELECT button until the Status indicator flashes quickly five times (approximately 5 seconds). 3.5.2 Switching Between DISH 500 Satellites Once the system is configured for DISH 500 mode, you can easily switch between the 119 and 110 satellites. Simply press the SAT SELECT button to switch from one to the other. IMPORTANT! Switch between satellites only while the vehicle is stationary or, if your system is a TracVision LF, while you are driving in a straight line. If you try to switch satellites while the vehicle is turning, the antenna may lock onto the wrong satellite. If this occurs, you will need to reset the system to the factory default (as described in the next section) then reconfigure the system for DISH 500 mode (as described in the previous section). 3.5.3 Resetting the System to Factory Default To reset the system to the factory default, in which the antenna searches for a different satellite whenever the SAT SELECT button is pressed, follow the steps below. 1. Turn off the TracVision system. 2. Press and hold the SAT SELECT button as you turn on the TracVision system. 3. Continue holding down the SAT SELECT button until the Status indicator flashes quickly five times (approximately 5 seconds). When you release the SAT SELECT button, the antenna starts up in the factory default mode. If you turn off the TracVision system, move the vehicle, then turn the system back on, the antenna may not be able to find the correct satellite upon startup.In this case, you will need to reset the system to the factory default and then reconfigure the system for DISH 500 mode. 54-0194 Addendum to Rev.D Congratulations! Congratulations! ® Industries’ TracVision® LF/SF is designed for use with DIRECTV®, DISH Network™, and ExpressVu. This manual provides detailed instructions on the proper installation, use, and maintenance of your TracVision LF/SF system. Before using this manual, be sure to check the inside back cover for any addenda, which may detail changes to the manual’s information. Throughout this manual, important information is marked for your attention by these icons: . . . . . . . . . . . . . . . . . . . . . . . . . . ... . . . . . . . . . . . . . . . . . . . . ... . . . . . . . . . . . . . . . . . . . . . Direct questions, comments, or suggestions to: KVH Industries, Inc. TracVision LF/SF Serial Number This serial number will be required for all troubleshooting or service calls made regarding this product. 50 Enterprise Center Middletown, RI 02842-5279 USA Tel: +1 401 847-3327 (Text Box comment Click here to go to our state-of-the-art Customer Support web page...the fastest and easiest way to get all of your questions answered!) Fax: +1 401 849-0045 E-mail: info@kvh.com Internet: If you have any comments regarding this manual, please e-mail them to manuals@kvh.com. Your input is greatly appreciated! KVH Part # 54-0194 Rev. D © 2004, KVH Industries, Inc., All rights reserved. TracVisionTracVisionand KVH® are registered trademarks of KVH Industries, Inc. DIRECTV® is an official trademark of DIRECTV, a unit of GM Hughes Electronics Corporation. DISH Network™ is an official trademark of EchoStar Communications Corporation. ExpressVu is a property of Bell ExpressVu, a wholly owned subsidiary of Bell Satellite Services. Table of Contents 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1 1.1 Digital Satellite Televis...
Dieses Handbuch ist für folgende Modelle:Sat-TV-Receiver - SF (1.09 mb)