Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
If this equipment does cause interference to radio or television reception (which you can determine by turning the equipment off and on), you are encouraged to try to correct the interference by one or more of the following measures: 1. Change the position of the Satellite Receiver with respect to the radio or television equipment that is receiving the interference. 2. Move the Satellite Receiver away from the equipment that is receiving the interference. 3. Plug the Satellite Receiver into a different outlet so that the Satellite Receiver and the equipment receiving the interference are on different branch circuits. 4. Use shielded cables and I/O cords with this equipment to comply with the relevant FCC regulations. 5. If these measures do not eliminate the interference, you should consult your dealer or an experienced radio/ television technician for help. IMPORTANT Any change or modifications to the equipment by the user not expressly approved by the warranty or manufacturer could void the user's authority to operate the equipment. Domestic use U.S.A - For units used at 100-120V, use only the power supply cord which is supplied with the product. General Information Federal Communication Commission (FCC) Part 68 ANALOG DEVICE WARNINGS This equipment complies with part 68 of the FCC rules. A label on the rear panel of this equipment contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company. The REN is used to determine the number of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. Note: RENs are associated with loop-start and ground-start ports. Do not use for E & M or digital ports. This equipment uses the following USOC jack: RJ-11C. No modular plug is provided with this equipment. If the DSX 5350 causes harm to the telephone network, the telephone company will notify you in advance that temporary interruption of service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. This equipment cannot be used on public coin phone service provided by the telephone company. Connection to party line service is subject to state tariffs. (Contact the state public utility commission, public service commission or corporation commission for information.) For repair or warranty information on hardware service only, please call: 1-800-464-1131. 4 Table Of Contents Overview.............................................................................. .... 6 Options Menu ....................................... ...............................30 Modes .................................................................................... 7 Messages ................................................. ...............................31 Preparing your Remote Control .............................. .... 8 Using the Menu ................................... ...............................32 Controls and Connections.......................................... 9 General Settings ................................. ...............................33 Connecting to your Existing Equipment.............. ..10 Screen Format..................................... ...............................33 Inserting your Access Card........................................ 1? Banner Duration ................................. ...............................34 Replacing the Access Card.......................................... ..13 Access Control ..................................... ...............................35 Remote Control Use...................................................... ..14 Language ................................................. ...............................38 On Screen Installation.................................................. 19 Upgrades ................................................. ...............................41 General Operation of your DIRECTV PLUS™ Mail............................................................. .......