Stimmen - 4, Durchschnittliche Bewertung: 3.3 ( )

Hersteller: ACR Electronics Dateigröße: 1.46 mb Dateiname: cb535e73-bcea-4fca-9003-915bccd06591.pdf Unterrichtssprache:

The beacon will slide up and out of the bracket. On either side of the bracket are release tabs. Simultaneously depress each tab to separate the bracket from the mounting block. The mounting block can be held in place to mark the placement of the screw holes or you can use the mounting template provided. The use of #8 pan head stainless steel fasteners and washers (not included) is recommended. Be sure to confirm that fasteners will not contact any wires or plumbing before drilling pilot holes. Mounted to wall . LATCH CLOSED . LATCH OPEN . . . STEP FOUR - MAINTAINING THE BEACON 1. Safety DOs and DON’Ts On a routine basis aboard ship, DO NOT: // Hold or carry the beacon by its antenna // Mount the beacon in its bracket close to large structures or magnetic areas // Tie the lanyard to the EPIRB bracket or any other structure // Obscure the beacon by placing objects in front of it On a routine basis aboard ship, DO: // Mount the beacon in its bracket in an obvious location, so that all can see it // Mount the beacon in its bracket with the rolled lanyard facing inward (facing the bracket) // Follow the recommended maintenance schedule // Perform a beacon Self-Test monthly // Follow up with beacon service if Self-Test fails 2. Routine beacon maintenance At least every ninety days, the float free mounting bracket and beacon should be inspected for deterioration and/or residue buildup that may affect the function of the beacon or automatic release. Part of the visual check includes checking the antenna for tightness. Clean the beacon and the mounting bracket to remove any residue buildups. It is recommended that the beacon and mounting bracket be wiped with a damp cloth. Carefully inspect the beacon case for any visible cracks. Cracks may admit moisture, which could falsely activate the beacon or otherwise cause a malfunction. Any cracks observed should immediately be referred to ACR Service for evaluation. Call ACR Electronics Technical Service +1 (954) 981- 3333. 3. Battery replacement Battery replacement is due 5 years from date after the beacon placed into service, or by expiry date on the beacon whichever is first. During each inspection, check the time remaining until battery replacement is required. The battery must also be replaced if the beacon has been activated for any use other than the Self-Test. Always refer battery replacement and any other beacon service to a factory authorized Service Center. Find a Center near you at Battery replacement includes servicing the beacon by replacing all o-rings, testing the water seal and the electrical properties and doing a full functional test on the unit. NOTE: There are no user serviceable items inside the beacon. Do not open the beacon except to disable (in case of faulty or accidental activation). Otherwise, always have the beacon serviced. WARNING: Battery contains lithium To avoid possible fire, explosion, leakage or burn hazard, do not open, recharge, disassemble or heat beacon above +70.C (+158.F) or incinerate. These products contain lithium in the battery. Various beacons may or may not require special shipping instructions due to the lithium batteries and changes in shipping regulations. Shipping of hazardous materials requires special handling and documentation. MSDS sheets, along with shipping information, can be found on our website at In the case of the RLB-37, the product contains small batteries that are non- hazardous. However, regulations can change. Be advised that it is best to verify the shipping requirements at the time you are preparing to ship the unit. 4. Shore based maintenance for SOLAS vessels, (SBM) IMO MSC/Circ. 1039 The Maritime Safety Committee has approved guidelines for shore-based maintenance of satellite beacons, for the purpose of establishing standardized procedures and minimum levels of service for the testing and maintenance of satellite beacons. The first shore based maintenance on all ACR EPIRBs is due at the date of the first battery replacement. Visit ACR’s website at for organizations that perform shore based maintenance. 5. Annual testing for SOLAS vessels, IMO MSC/Circ. 1040 SOLAS regulation IV/15.9 dictates annual testing of 406 MHz satellite EPIRBs. Testing should be carried out using suitable test equipment capable of performing the relevant measurements. All checks of electrical parameters should be performed in the self-test mode, if possible. These tests can be performed by certified ACR Battery Replacement Centers (BRCs). Visit ACR’s website at for authorized ACR BRCs. 6. Changing ownership or contact information As the owner of the beacon, it is your responsibility to advise the national authority of any change in the information on the registration form. If you are transferring the beacon to a new owner, you are required to inform the national authority. You can do this by u...

Herunterladen

Geben Sie zwei Ziffern: