Stimmen - 4, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
2. Insert safety ignition key. 3. Fill fuel tank. 4. Move throttle to FAST position. 5. Move to FULL position. 6. Prime as instructed in the Operation section of this manual. 7. Wait a few minutes before restarting, DO NOT prime. 8. Connect wire to spark plug. 9. Replace spark plug. 10. Drain fuel tank and carburetor, refill tank with fresh gasoline. 11. Drain fuel tank and carburetor, refill tank with fresh gas o line. Loss of power 1. Spark plug wire loose. 2. Throwing too much snow. 3. Fuel tank cap is covered with ice or snow. 4. Dirty or clogged muffler. 1. Reconnect spark plug wire. 2. Reduce speed and width of swath. 3. Remove ice and snow on and around fuel tank cap. 4. Clean or replace muffler. Engine idles or 1. Choke is in FULL position. 1. Move choke to OFF position. runs roughly 2. Blockage in fuel line. 3. Stale fuel. 4. Water in fuel. 5. Carburetor is in need of adjustment or overhaul. 2. Clean fuel line. 3. Drain tank and refill with fresh, clean fuel. 4. Drain fuel tank and carburetor, refill tank with fresh gasoline. 5. Contact a qualified service centre. Excessive vibration 1. Loose parts or damaged augers or impeller. 1. Tighten all fasteners. Replace damaged parts. If vibration remains, contact a qualified service centre. Recoil starter is hard to pull 1. Frozen recoil starter. 1. See “IF RECOIL STARTER HAS FROZEN” in the Operation section of this manual. Loss of traction drive / slowing of drive speed 1. Drive belt is worn. 2. Drive belt is off of pulley. 3. Friction drive wheel is worn. 1. Check / replace drive belt. 2. Check / reinstall drive belt. 3. Contact a qualified service centre. Loss of snow 1. Auger belt is off of pulley. 1. Check / reinstall auger belt. discharge or 2. Auger belt is worn. 2. Check / replace auger belt. slowing of 3. Clogged discharge chute. 3. Clean snow chute. snow discharge 4. Augers / impeller jammed. 4. Remove debris or foreign object from augers / impeller. 18 SERVICE NOTES 19 20 REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001801) AUGER HOUSING / IMPELLER ASSEMBLY 6 6 5 9 9 12 7 7 8 6 11 57 10 13 4 14 16 15 36 37 50 47 42 42 44 27 27 43 43 46 38 45 41 40 39 34 32 49 48 19 51 33 35 30 56 31 19 19 55 26 10 22 25 20 18 58 25 26 29 20 10 17 17 28 55 28 18 58 07 AIG plug_r1 REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001801) AUGER HOUSING / IMPELLER ASSEMBLY KEY PART KEY PART NO. NO. DESCRIPTIONNO. NO. DESCRIPTION 4 191079 Pulley, Impeller 30 405973X479 Auger Assembly, RH5 188909 Bearing Assembly, Flange 31 405972X479 Auger Assembly, LH6 155377 Nut, Hex Flange 5/16-18 32 407768 O-Ring 7 180355 Bolt, Flat Head, Carriage 33 407769 Bushing, Flange 3/4 5/16-18 x 5/8 34 174681 Washer, Thrust 3/4 8 72270505 Bolt, Carriage 5/16-18 35 174684 Bearing, Thrust 3/49 163183 Bolt, Hex Head 36 407757 Shaft, Impeller 10 404930X428 Housing, Auger37 174683 Washer, Thrust 5/8 11 404933X479 Bar, Scraper 38 407758 Bushing, Flange 5/8 12 178675X008 Bracket, Corner Discharge 39 407767 Screw, Hex Head 5/16-18 x 3/413 175322 Base, Discharge Chute 40 407760 Plug, Case 14 10040500 Washer, Lock 5/1641 407761 Housing, Gearbox, RH 15 19111507 Washer, Flat 42 407770 Seal, Oil 16 74940516 Screw, Hex Head 5/16-18 x 3/443 407762 Bushing, Flange, 1" 17 405637 Grease Fitting 44 189282 Key, Square 1/4 x 1/4 x 7/818 179582 Screw, Hex Head 5/16 x 1 45 407763 Gear, Worm19 73800400 Nut, Hex Lock 1/4-20 46 407764 Shaft, Auger 20 155377 Nut, Hex Lock 5/16-18 47 407765 Housing, Gearbox, LH22 178777X479 Skid Plate, RH 48 175321X479 Impeller Assembly 25 72270506 Bolt, Carriage 5/16-18 x 3/449 74780426 Screw, Hex Head 1/4-20 x 1-5/8 26 174658 Bearing, Auger 50 407766 Gasket, Gearbox 27 174697 Washer, Thrust, 1"51 7836M Pin, Roll 3/16 x 1-1/8 28 198636 Bolt, Shear 55 198638 Spacer29 174762X479 Skid Plate, LH 56 180684 Multi-Wrench 57 196710 Gearbox Assembly 58 411939 Plug, Bearing, Hole, HSG NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 21 22 REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001801) CONTROL PANEL / DISCHARGE CHUTE 3 1 2 2 6 19 2 2 26 28 27 27 25 20 29 7 4 5 6 8 8 16 18 17 10 14 3 13 15 9 11 12 22 23 22 23 31 32 30 REPAIR PARTS SNOW THROWER - MODEL PP10530ES (96192001801) CONTROL PANEL / DISCHARGE CHUTE KEY PART NO. NO. DESCRIPTION 1 414280 Knob, Lever 2 17501010 Screw #10-24 x 5/8 3 198475 Control Assembly, Deflector 4 73800600 Nut, Lock 3/8-16 5 19131316 Washer, Flat 3/8 6 404974 Control Assembly, Chute Rotater 7 405784X479 Support, Pivot 8 150078 Screw, Hex Head 5/16-18 x 3/4 9 184505 Spring, Deflector 10 179829 Bolt, Shoulder 11 179246 Washer, Friction, Nylon 12 191730 Nut, Lock 1/4-20 13 72250505 Bolt, Carriage 5/16-18 14 751153 Nut, Lock 5/16-18 15 404770X428 Chute Assembly 16 178633X428 Deflector Assembly 17 179145 Seal, Deflector 18 128415 Rivet, Blind 19 414281 Knob, Speed Control ...