Stimmen - 2, Durchschnittliche Bewertung: 5 ( )

Hersteller: Craftsman Dateigröße: 1.74 mb Dateiname: Unterrichtssprache:

Note, install the rear bolt first for easier alignment. 2. Tighten bolts securely with a wrench. 3. Lift up folding handle to align it with lower handle and tighten the wing knobs securely as shown in Figure 3. The snow thrower is now ready for operation once the fuel tank has been filled with the properly mixed gasoline and two cycle oil. Figure 1. Assembly of Discharge Chute A. Discharge Chute D. Nuts B. Carriage Bolts E. Rotating Ring C. Washers A B C D E Figure 2. Handles A. Handle B. Wing Knobs A B Figure 3. Lift Handles and Lock Wing Knobs 6 Controls & Operation Auger Control Chute Direction Control Chute Deflector A B C Engages auger when pulled back, and disengages auger when released. Rotates discharge chute to desired direction Controls vertical angle snow is thrown. Figure 4. Snowthrower Controls A B C SNOWTHROWER CONTROLS Auger Control A. Auger Control - This control engages and disengages the auger. Pull the control back against handle to engage the auger, (this will pull snowthrower forward if auger is in contact with the ground). Release the Auger Control to stop rotation of auger. Deflector Controls B. Chute Direction Control - The Chute Direction Control (B, Figure 4) allows the discharge chute to be rotated to throw snow in the desired direction. Snow may be thrown at any angle from straight left to straight forward, to straight right. C. Chute Deflector - Controls the distance snow is thrown. Tilting the Chute Deflector (C, Figure 4) UP provides a higher stream and greater distance, while tilting the deflector DOWN provides a lower stream and less distance. Controls & Operation ENGINE & STARTING CONTROLS NOTE: Throttle -This snow thrower does NOT have a throttle for controlling operating speed of engine.The engine governor maintains operating speed for varying snow removal conditions. Electric Start Units Only A. Electric Start Button -The Electric Start Button (A, Figure 5) activates an electric starter mounted to the engine, eliminating the need to pull the starter handle. The Electric Start Button operates on 120 Volts AC, which is provided by connection to the extension cord provided with units equipped with this feature. Connect this extension cord ONLYto a properly grounded 3 prong electrical outlet. All Models B. Fuel Tank Cap -Cover fuel tank & provides venting ability to prevent vapor lock. C. Starter Handle -The starter handle (C, Figure 5) connects to a starter cord to manually start the engine. Pulling starter handle rapidly spins the engine crankshaft, cycles the engine, and generates the spark necessary for starting the engine. D. Primer Button -When pressed, the Primer Button (D, Figure 5) provides initial fuel to help start a cold engine. Normally, pressing the primer button twice will provide enough fuel to start a cold engine. E. Engine Key -Insert key in switch and turn key to ON position when starting engine. To stop engine, turn key to OFF position. F. Choke Control -The is control (F, Figure 5) adjusts the...

Herunterladen

Geben Sie zwei Ziffern: