Stimmen - 2, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Craftsman Dateigröße: 812.91 kb Dateiname: Unterrichtssprache:

Auger Control B. Drive Control D. Chute Direction Control C B D E G A F Figure 5. Snowthrower Operating Controls H Scraper Bar A. Speed Selector E. Chute Deflector B. Drive Control F. Chute Deflector Knob C. Auger Control G. Skid Shoes D. Chute Direction Control H. Traction Lock Pins TRACTION LOCK CONTROL H. Traction Lock Pins - The traction drive to each wheel can be locked and unlocked with the Traction Lock Pins (H, Figure 5) to permit the unit to “freewheel,” allowing easier manual handling and transport of the snowthrower. 7 Operation GENERAL OPERATION CHECKS BEFORE EACH START-UP 1. Make sure all safety guards are in place and all nuts, bolts and clips are secure. 2. Check the engine oil level. See your engine Owner’s Manual for procedure and specifications. 3. Check to make sure spark plug wire is attached and spark plug is tightened securely. If necessary, torque spark plug to 15 ft. lbs. 4. Check the fuel supply. Fill the tank no closer than 1/4 to 1/2 inch of top of tank to provide space for expansion. See your engine Owner’s Manual for fuel recommendations. 5. Check the Scraper Bar to make sure it is set at the desired height. Adjust the Skid Shoes if necessary. (See page 10.) 6. Check the Drive Control (B, Figure 1), and Auger Control (C, Figure 1) for proper operation. If adjustment is required, see the Service section (pages 1617) for procedures. 7. Check the Chute Direction Control (D, Figure 1) for proper operation. The discharge chute should rotate freely in both directions. See the Service section for adjustment procedures and troubleshooting. 8. Check the Chute Deflector (E, Figure 1) for proper operation. The deflector should pivot freely up and down when the Chute Deflector Knob is loosened. If adjustment is required, see the Service Section for procedures. 9. Position the chute at the desired starting direction and set the deflector at the desired angle. 10. Check the Speed Selector (A, Figure 1) for smooth operation. The control must move freely into each speed position gate and remain in position when released. If the Speed Selector does not move freely into all forward and reverse speed positions, contact your local authorized dealer for assistance. WARNING To avoid serious injury, do not put your hands into the auger housing or discharge chute. If auger stalls or chute becomes plugged, use the following procedure to remove objects or clear the chute: 1. Release both the Drive and Auger Control levers. 2. Shut off the engine. 3. Remove the Engine Key. 4. Wait for moving parts to stop. 5. Disconnect spark plug wire. 6. Use a narrow board to remove foreign objects and clear the chute or auger. Never put your hands into the auger or discharge chute. WARNING For your safety, operation on slopes should be in an up and down direction only. If it becomes necessary to move across the face of a slope, use caution and do not blow snow. Be very careful when changing direction on a slope. Proper winter footwear is recommend...

Herunterladen

Geben Sie zwei Ziffern: