Tighten screws holding leveling bracket to unit on each side. 3 INSTALL DUCTWORK CAUTION -BEFORE CUTTING HOLE IN CABINET FOR DUCTWORK: Check for interference with floor joists, wall studs, electrical wiring or plumbing. 6" RD. ELBOW & DUCT- WORK 3-1/4" X 10" TO 6" RD. TRANSITION BLOWER COLLARSCREWS 1. Cut hole in cabinet as well as holes in wall or floor as necessary. 2. Mount the roof or wall cap and work back towards the cabinet, attaching all ductwork, elbows and transitions as previously pl

If you have questions, contact the manufacturer at the address or telephone number in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 3. Installation work and electrical wiring must be done by a qualified person(s) in accordance wi

NuTone READ & SAVE THESE INSTRUCTIONS! INSTALLATION INSTRUCTIONS Heat-A-Ventlite® MODELS: QT-9093 SERIES IMPORTANT: DO NOT MOUNT OVER TUB OR IN SHOWER STALL ENCLOSURE. PRECAUTIONS_ • Observe all requirements in this instruction sheet and all markings appearing on the unit. • Check all operations of the unit after installation has been completed. • The heater housing must be grounded and the wiring must comply with all local electrical codes. • The flange of the rough-in housing MUST be