Stimmen - 3, Durchschnittliche Bewertung: 3.7
(
)
)
|
Anleitung Zusammenfassung
5). 2. Press and hold the release button (Fig. 5). 3. While firmly holding the upper shaft housing, pull the blower/vaccuum add-on out of the coupler (Fig. 6). Installing the add-on WARNING: To avoid serious personal injury and damage to the unit, shut unit off before removing or installing add-ons. 4. Turn the knob clockwise to tighten (Fig. 7). Primary Hole Upper Shaft Housing Coupler Fig. 6 Lower Shaft Housing Release Button Knob CAUTION: Lock the release button in the primary hole (Fig. 6) and securely tighten the knob before operating this unit. Knob NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench. 1. Remove the hanger from the top of the shaft housing. 2. Turn knob counterclockwise to loosen (Fig. 5). 3. While firmly holding the add-on, push it straight into the coupler (Fig. 6). Coupler Release Button Guide Recess ClockwiseCounterclockwise Knob Fig. 5 NOTE: Aligning the release button with the guide recess will help installation (Fig. 5). Fig. 7 CAUTION: The add-ons with the coupler system are to be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit. The blower/vacuum add-on should be installed with the release button in the primary hole. Check Flex Shaft Engagement Prior to Using 1. Start the unit. 2. Briefly engage and release the trigger. 3. Check that add-on is operating. 4. If the add-on is not operating, remove add-on and repeat steps for installing the add-on. 5. Recheck operation of add-on attachment. OPERATING INSTRUCTIONS 9 Fig. 8 Fig. 9 Fig. 10 OPERATING TIPS NOTE: Move the unit slowly back and forth over debris to be vacuumed or blown. NOTE: Vacuum a large pile of debris by working from the outside of the pile. Do not force the suction tube into the debris because this can clog the unit. OPERATING VACUUM 1. The vacuum can be used for cleaning around rocks, under shrubs and trees, along walls, or vacuuming piles of debris formed by blower (Fig. 8). 2. Disconnect unit from power source before removing bag. Once removed, shake the bag vigorously while emptying to completely remove the contents (Fig. 9). OPERATING BLOWER 1. You can blow debris from around buildings, trees, shrubs, and flower beds, or into a pile to be vacuumed (Fig. 10). OPERATING TIPS • Be sure the vacuum bag is zipped closed before operating the unit. • Assure the unit is not directed at loose debris or persons before starting unit. • The unit is in good working condition. The tubes and guards are in place and secure. • Always hold the unit with both hands when operating. Keep a firm grip on both the front and rear handle or grips. • To reduce the risk of hearing loss associated with sound level(s), the use of hearing protection is required. • Watch out for children, pets, open windows, or freshly washed cars, and blow debris away. • After using blowers and other equipment, CLEAN UP! Dispose of debris in trash receptacles. MAINTENANCE AND REPAIR INSTRUCTIONS STORAGE • Check unit before storage to be sure the equipment is in safe working condition. • Stop the engine or motor. • Store the unit indoors, in a dry and locked place, out of the reach of children. For gas powerhead units • Allow the unit to cool before storing in any enclosure. • Drain fuel from unit. Never store the unit with fuel in the fuel tank inside a building where ignition sources are present such as hot water and space heaters, clothes dryers, etc. TRANSPORTING • Allow the unit to cool before transporting. • Secure the unit while transporting. For gas powerhead units • Drain fuel from unit. • Tighten fuel cap before transporting. ACCESSORIES/REPLACEMENT PARTS Vacuum bag assembly . . . . . . . . . . . . . . . . .791-180108 Vacuum tube assembly . . . . . . . . . . . . . . . . . . .753-1215 Blower tube assembly . . . . . . . . . . . . . . . . . .791-181641 Use only original genuine factory replacement parts. SPECIFICATIONS BLOWER/VACUUM ADD-ON Weight of Attachment: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.6 lbs. (10.1 kg) Bag Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Bushels (.0728 m3) Air Velocity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Up to 120 MPH Drive Shaft Housing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Steel Tube MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing ...
Dieses Handbuch ist für folgende Modelle:Lüftungs - TBBV (868.37 kb)