Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: Tanaka Dateigröße: 513.37 kb Dateiname: Unterrichtssprache:

• Empty the fuel tank before storing the tool. It is recommended that the fuel be emptied after each use. If fuel is left in the tank, store so fuel will not leak. • Store tool out of the reach of children. • Clean the unit carefully and store it in a dry place. • Make sure engine switch is off when transporting or storing. If situations occur which are not covered in this manual, take care and have good judgment. Contact your dealer if you need assistance. Pay special attention to statements preceded by the following words: WARNING! Indicates a strong possibility of severe personal injury or loss of life, if instructions are not followed. CAUTION! Indicates a possibility of personal injury or equipment damage, if instructions are not followed. NOTE! Helpful information for correct function and use. 3 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 3. Assembly procedures. Blow pipes to main body (Fig. 1-1) Inspect the main body and accessories, Connect straight pipe (1) and other pipe(s) securely. (See page 1) Align groove (2) in straight pipe with projection (3) on blower housing (or another pipe) and slide the pipe onto the blower housing (or another pipe). Rotate the pipe clockwise to lock it into place, then tighten the clamp band (if so equipped, THB-2510). NOTE! (TBL-4600, optional) . Connect flexible pipe (2) to main body with clamp (1). Finger-tighten the clamp. . Connect swivel pipe (4) to flexible pipe with clamp (3). . Install throttle grip (5) to swivel pipe so that the grip locates 2-3 cm away from projection (6) on swivel pipe. . Finally, if direction of bent pipe does not match the direction of throttle grip, loosen knob (7) or wing bolt (8) (enclosed in vinyl bag) and swivel the grip to your comfort. (Fig. 1 - 1 B) NOTE! (TBL-4600/4610/505, optional) . Use flexible pipe with wire clamps. . Install the pipe handle on swivel pipe or on straight pipe. Decide location and direction to your comfort. (Fig. 1-2) NOTE! (THB-2510, optional) Vacuum attachment is offered as an optional kit, which converts the hand-held blower into a vacuum cleaner. For installation, see THV-200 vacuum manual. 4 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 THB-2500/THB-2510/TBL-4600/4610,TBL-505 4. Operating procedures. WARNING! This unit is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel. Fuel . Always use branded 89 octane unleaded gasoline. . Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil (B)), only for the state of California at 50: 1. . Never use multi-grade oil (10 W/30) or waste oil. . Always mix fuel and oil in a separate clean container. Always start by filling half the amount of fuel, which is to be used. Then add the whole amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of fuel. Mix (shake) the fuel-mix thoroughly before filling the fuel tank. Fueling WARNING! * Always shut off the engine before refueling. *Slowly open the fuel tank, when filling up with fuel, so that possible over-pressure disappears. Tighten the fuel cap carefully, after fueling. *Always move the unit at least 3 m (10 ft.) from the fueling area before starting. Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the tank. Make sure that the fuel is well mixed by shaking the container, before fueling. 5 custsvc@tanaka-ism.com Owner.s ManualTHB-2500/THB-2510/TBL-4600/4610,TBL-505 THB-2500/THB-2510/TBL-4600/4610,TBL-505 Starting CAUTION! Do not start if the pipe is obstructed by the ground or any other object. 1 .Set ignition switch (1) to ON position. (Fig. 2-2, 2B, 2C) . Push priming bulb (4) several times so that fuel flows through return pipe (5) (if so equipped) (Fig. 2-3, 3B) . Move throttle lever to a half-open position (2) and lock it with lock lever (4) (if so equipped), when it is hard to start engine. (Fig. 2-2C) Note! (TBL-4610) Mod...

Herunterladen

Geben Sie zwei Ziffern: