|
Anleitung Zusammenfassung
Service the air cleaner element. Tighten or replace the spark plug. Check the Specifications section for the correct plug and gap for your unit. Repair or replace fuel filter and/or fuel line. Refill with fresh, clean unleaded gasoline with a pump octane of 89 or higher mixed with an air cooled engine oil that meets or exceeds ISO-L-EGD and/or JASO FD classified oils at 50:1 gasoline/oil ratio. Consult with an authorized Shindaiwa servicing dealer. Engine is rough at all speeds. May also have black smoke and/or unburned fuel at the exhaust. Engine is knocking. Overheating condition. Consult with an authorized Shindaiwa servicing dealer. Improper fuel. Refill with fresh, clean unleaded gasoline with a pump octane of 89 or higher mixed with an air cooled engine oil that meets or exceeds ISO-L-EGD and/or JASO FD classified oils at 50:1 gasoline/oil ratio. Carbon deposits in the combustion chamber. Consult with an authorized Shindaiwa servicing dealer. Troubleshooting Guide (continued) ADDITIONAL PROBLEMS Symptom Poor acceleration. Possible Cause Clogged air filter. Clogged fuel filter. Lean fuel/air mixture. Idle speed set too low. Remedy Clean the air filter. Replace the fuel filter. Consult with an authorized Shindaiwa servicing dealer. Adjust idle. Check Specifications page for correct idle speed. Engine stops abruptly. Engine difficult to shut off. Excessive vibration. Top of engine is getting dirty and oily. Idle set too high. Adjust idle. Check Specifications page for correct idle speed.Engine will notidle down. Engine has an air leak. Consult with an authorized Shindaiwa servicing dealer. Ignition switch turned off. Fuel tank empty. Water in the fuel. Clogged fuel filter. Shorted spark plug or loose terminal. Ignition failure. Piston seizure. Heat sensor is activated, due to restricted air flow at intake cover. (EB854 ONLY) Ground (stop) wire is disconnected, or switch is defective. Overheating due to incorrect spark plug. Overheated engine. Valve cover is leaking. Debris build-up in impeller. Loose or damaged impeller. Loose or damaged engine mounts. Reset the switch and re-start. Refill with fresh, clean unleaded gasoline with a pump octane of 89 or higher mixed with an air cooled engine oil that meets or exceeds ISO-L-EGD and/or JASO FD classified oils at 50:1 gasoline/oil ratio. Replace fuel filter. Clean or replace spark plug. Check the Specifications section for the correct plug and gap for your unit. Tighten the terminal. Replace the ignition unit. Consult with an authorized Shindaiwa servicing dealer. Clean debris blocking intake cover. Restart. Idle more than 1 minute. If engine stops again, consult with an authorizedShindaiwa servicing dealer. Test and replace as required. Replace the spark plug. Check the Specifications section for the correct plug and gap for your unit. Restart. Idle engine until cool. Consult with an authorized Shindaiwa servicing dealer. Clean debris from impeller as required. Inspect and replace impeller as required. Tighten or replace engine mounts as required. Engine overspeeding. Blower intake or discharge ports or tubes are clogged with debris. Inspect and remove debris. Impeller blades are missing or damaged. Consult with an authorized Shindaiwa servicing dealer. SHINDAIWA LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010 ECHO, INC’S RESPONSIBILITY ECHO Incorporated’s (ECHO, INC.) Limited Warranty, provides to the original purchaser that this Shindaiwa product is free from defects in material and workmanship. Under normal use and maintenance from date of purchase, ECHO, INC. agrees to repair or replace at it’s discretion, any defective product free of charge at any authorized Shindaiwa servicing dealer within listed below application time periods, limitations and exclusions. THIS LIMITED WARRANTY IS ONLY APPLICABLE TO SHINDAIWA PRODUCTS SOLD BY AUTHORIZED SHINDAIWA DEALERS. IT IS EXTENDED TO THE ORIGINAL PURCHASER ONLY, AND IS NOT TRANSFERABLE TO SUBSEQUENT OWNERS EXCEPT FOR EMISSION RELATED PARTS. Repair parts and accessories replaced under this warranty are warranted only for the balance of the original unit or accessory warranty period. Any damage caused by improper installation or improper maintenance is not covered by this warranty. All parts or products replaced under warranty become the property of ECHO, INC. This warranty is separate from the Emission control warranty statement supplied with your new product. Please consult the Emission Control Warranty Statement for details regarding emission related parts. For a list of Authorized Shindaiwa Dealers refer to WWW.SHINDAIWA.COM or call 1-877-986-7783. OWNER’S RESPONSIBILITY To ensure trouble free warranty coverage it is important that you register your Shindaiwa equipment on-line at WWW.SHINDAIWA. COM or by filling out the warranty registration card supplied with your unit. Registering your product confirms your warranty coverage and provides a direct link if we find it necessa...
Dieses Handbuch ist für folgende Modelle:Lüftungs - EB854 (2.1 mb)
Lüftungs - EB854RT (2.1 mb)