Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
The plug is configured for the appropriate electrical supply. DUTY CYCLE Your shredder is designed for continuous use when shredding paper. When shredding CDs we recommend a duty cycle of 20 CDs maximum followed by a 15-mlnute cool off period. If you exceed that volume you may activate the motor's automatic thermal protection. Your shredder will automatically reset and be ready for use after the cool off period, SERVICE Do not attempt to service or repair the unit yourself! In the rare event that your unit requires Service contact your dealer or call GBC National Service at 1-800-790-7787. FIGURE 3. SETUP To insure proper installation and avoid injury, GBC recommends that two people set up this unit. To protect against damage, your shredder has been shipped in two parts, the shredder head A, the cabinet 8. FIGURE 1. Lock the casters (A) before using the machine to prevent any moving or sliding. Open the cabinet door. Lift the shredder head by the outside edges and place onto the cabinet. FIGURE 2. Remove the wire bag rim from the cabinet. Place one large shredder bag and one small CD bag onto the rim as shown. Slide the rim with bags back Into the cabinet, close the door. Your shredder ready for use! MATERIALS YOU CAN SHRED Your shredder can handle most any type of office paper documents. You can safely shred documents containing staples, however, other metal items may damage the shredder. The 3550X shredder will also shred CDs using its dedicated feeding slot. OPERATION -FIGURE 3. Connect power cord to an appropriate power source. Press the rocker switch (A) to the on "I" position. When the shredder is properly set up with cabinet door fully closed, the Power On light (B) will illuminate. You are now ready to shred! To shred simply insert paper into the throat of the unit. Once your document has activated the Automatic On switch the unit will start and then will stop once your document is shredded. CD SHREDDING To shred a CD, simply insert a single CD into the dedicated feeding throat and depress ttie start switch (F). Shredder will stop automatically after 5 seconds of running time. Do not feed CDs into the larger throat. BIN FULL S In order to prevent shreds from backing up into the cutters and jamming your shredder this unit features an automatic bin full shut off. Once the shred bin is full the unit will shut off automatically and the Bin Full light (C) will illuminate. You can now either compact the shreds and continue shredding, or empty the shred bag. DOORAJAR Your shredder is equipped with a safety interlock which will not allow the unit to operate if the cabinet door is open. The Door Ajar light (D) will illuminate if your cabinet door is not fully closed. OVERLOAD 8^ If too much paper Is inserted into the throat of the unit the shredder will sense an overload and the Overload Light (E) will illuminate. The shredder will switch to reverse mode automatically to clear the paper of the throat area. Separate your pages into smaller sets, switch your unit back into the Power on position and shred. FIGURE 1. FCC Class В Notice - Notification pour les Etats-Unis Note: This equipment has been tested and found to comply with the limits tor a Class В digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician tor help. Canada Class В Notice - Avis Canada, Classe В This Class В digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la dasse В est conforme á la norme NMB-003 du Canada. Modifications Any modifications made to this device that are not approved by General Binding Corporation may void the authority granted to the user by the FCC and/or by Industry Canada to operate this equipment. Toutes modifications apportées á ce disposrtrf et non approuvées par General Binding Corporation annuleront le droit accordé á I'utilisateur par le FCC el/ou par Industrie Canada de faire fbnctionner cet equipemerrt MAINTENANCE For best performance it is recommended that you oil the cutting blades whenever a decrease in shred capac-ity is noticed. Follow...