Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: GBC Dateigröße: 608.31 kb Dateiname: Unterrichtssprache:

Jam Free™ Technology Jam Free Shredders will only shred stacks of paper that are within the shredders sheet capacity. Sensors in the paper feed area measure the thickness of paper about to be shredded. The ability to shred or not is communicated through red and green lighting. Green means that the stack of paper is within the shredders sheet capacity and OK to shred. Red means that you have too much paper, remove some sheets in order to shred. Given that you are unable to shred more sheets of paper than the shredder is capable of shredding, paper jams are prevented. This prevents time wasted through reversing paper and unblocking jams not to mention the mess it can create. RDM1050 and RDSM750 only. This means do not shred CD’s. This means do not shred credit cards. This means do not shred paper clips. This means do not shred staples. Rare Occasions of Jamming In the unlikely event of the shredder jamming, use the reverse function to unblock the shredder. (see Reverse function section) Alternating between the reverse function and the forward run (Hold Auto start for 2 seconds) will help unblock the feed area. Once the jam is clear, press the right hand auto button once to revert back to auto mode. You can now resume shredding as normal. Over Heating If the shredder is used continuously for long periods of time the shredder may overheat. If this occurs the thermometer symbol on the indicator panel will flash amber, the green will go off and you will see the red . When the shredder is ready to be used again the thermometer symbol will stop flashing and the green will show once again. To resume shredding press the auto button. Operation 1 After unpacking the product, pull out the shredder bin and remove the CD shard tray,which sits on top of the bin. Store this tray somewhere safe and use when you shred CD’s or credit cards to separate waste for recycling. (not applicable for GDM10 and GDHS7 models) 2 Connect shredder to mains supply. 3 Press the central power on button (d). This will switch the power on and all the LED warning symbols on the indicator panel (a) will flash in sequence. The shredder will now be in standby mode and the “Power-on” symbol on the indicator panel will be illuminated amber. 4 To start shredding, press the right hand auto feed button (e) this will illuminate the feed area green and illuminate the symbol green. This sets the shredder into auto mode and initiates the Jam Free mechanism. You are now able to shred. Reverse Function 1 Should you wish to reverse the shredding direction while shredding a document, a reverse button (f) has been fitted for your convenience. 2 By pressing the reverse button the shredding cutters will change direction allowing the retrieval of the document being shredded. The feed area will turn to red. 3 The reverse function will only run while the button is being pressed. When the reverse button has been released the shredder will revert to stand by mode. 4 To turn back to auto mode simply press the ...

Herunterladen

Geben Sie zwei Ziffern: