3. Screw the threaded clamp nut onto the spindle (D). 4. Rotate the spindle by hand while pressing the spindle lock fully until it has found its locking location and holds the spindle still (E). 5. Firmly tighten the threaded flange with the supplied hex wrench (F). Mounting Edge Cutting Wheels (Fig. 2) Type 27 Edge cutting wheels are available as optional accessories. Before fitting a cutting wheel, unplug tool from the power source. 1. Locate the inner clamp nut (A) on the machine spindle (B).

8. CLEAN UP ALL REMOVED PAINT and dust by wet mopping the floors. Use a wet cloth to clean all walls, sills and any other surfaces where paint or dust is clinging. DO NOT SWEEP, DRY DUST OR VACUUM. Use a high phosphate detergent or trisodium (TSP) to wash and mop areas. 5 901397 - 09-30-01.qxd 2/13/02 2:11 PM Page 6 9. AT THE END OF EACH WORK SESSION put the paint chips and debris in a double plastic bag, close it with tape or twist ties and dispose of properly. 10. REMOVE PROTECTIVE CLOTHING an

Record these numbers in the spaces below and retain for future reference. Model No. ______________________________________ IMPORTANT Please make certain that the person who is to use this equipment carefully reads and understands these instructions before starting operations. ESPANOL: PAGINA 17 FRANCAISE : PAGE 33 MODEL 340 Double Insulated Finishing Sander Type ___________________________________________ Serial No. _______________________________________ Copyright © 2005 Porter-Cable Part No. A