Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Hersteller: Elektra Beckum Dateigröße: 1.35 mb Dateiname: Unterrichtssprache:

The warranty period begins with the date of the original purchase by the end user. Proof of purchase should be retained and must be presented in the event of a warranty claim. This warranty excludes and does not cover defects, malfunctions and failures caused by natural wear, overload, unreasonable use or failure to provide reasonable and necessary maintenance. In case of a defect notify your dealer or authorized service centre. The manufacturer reserves the right to change specifications and design without prior notice and without incurring obligation of any kind. Safety Information A grinding machine is a power tool developing high rpm's during operation. As with all power tools there is a certain amount of hazard involved with the operator and his use of the machine. Using the machine with the respect and caution demanded as far as safety precautions are concerned will considerably lessen the possibility of personal injury. If, however, normal safety precautions are overlooked or completely ignored, personal injury to the operator can develop. observe the following information: -Never work without safety goggles. -Ensure that machine can not be started by children. -Regularly check all bolted connections being tight. -Prior to commissioning tool rests and spark protection assemblies have to be installed. -To ensure safe operation the grinder should be bolted to a workbench, wall bracket or pedestal stand. -Do not operate machine without wheel covers in place. -The adjusting guard plate must be frequently set to compensate any wear of the grinding wheel. The distance between the adjusting guard plate and the grinding wheel must be kept as small as possible and never greater than 2 mm. -The work piece support must be set gradually to compensate any wear of the grinding wheel. The distance between the adjusting guard plate and the grinding wheel must be kept as small as possible and never greater than 2 mm. -Ensure that switch is in the OFF position before plugging in. -Use only faultless grinding wheels. -Never put your finger between tool rest and grinding wheel or between grinding wheel and wheel cover (risk of injury by squashing). -This appliance should be operated on a residual current device (RCD) of 30 mA capacity. -Check power cable and plug prior to every use. -Have a damaged power cable replaced by a qualified electrician without delay. Risk of electric shock if operated with a damaged power cable! -Wear suitable apparel with snug fitting sleeves. -Store grinding wheels in a dry place at a steady temperature if possible. -Never use damaged or malformed grinding wheels. -Mount grinding wheels only with the flanges supplied with the machine. The liners between flange and wheel must be of elastic material such as rubber, soft cardboard etc. -Do not attempt to enlarge the arbor bore of a grinding wheel. -Always pull out the plug before changing the grinding wheel, setting or repairing the double grinding machine. -Ensure safe footing when operating the bench grinder. -Always disconnect from power by pulling the plug -when the grinder is not used -when servicing or -when changing grinding wheels. -Do not expose this appliance to rain and do not use it in damp or wet locations. -Observe the maximum output/capacity of the grinding machine (see nameplate); do not subject it to overloads. -From time to ti...

Herunterladen

Geben Sie zwei Ziffern: