Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
For more information, about using WPS, select Documentation from the main menu and then see the on-line User Manual. Troubleshooting • You can use the LEDs on the front of the gateway to determine the status of the gateway and your Internet connection. If you cannot connect to the Internet, view the LEDs to make sure that all connections are secure and power is supplied. • There is a Power button on the rear panel of the gateway. This button must be in the On position when the gateway is in use. • You can return the gateway to its factory settings. On the bottom of the gateway, press and hold the Restore Factory Settings button for over 7 seconds. The gateway resets, and returns to its factory settings. Technical Support Thank you for choosing a NETGEAR product. Please call your Cable Internet Service Provider for technical support. You may also take advantage of NETGEAR technical support resources such as the NETGEAR online knowledge base at: Defective or damaged merchandise should be returned to your point-of-purchase representative. This information supersedes all support information printed on any NETGEAR packaging or documentation. Note to CATV System Installer Please call the CATV systems installer’s attention to section 820-93 of the National Electric Code which provides guidelines for proper grounding of this device. In particular, section 820-93 specifies that the coaxial cable shield must be connected to the grounding system of the building, as close to the point of cable entry as practical. Warning: When installing or realigning an outside antenna system, take extreme care to avoid any contact with the power lines or circuits. Contact with them could be fatal. Reference to the Grounding Figure The numbers in the figure on the right indicate: 1. Electric service equipment 2. Power service grounding electrode system (NEC Art 250, Part H) 3. Ground clamps 4. Grounding conductors (NEC Section 810-21) 5. Antenna discharge unit (NEC Section 810-20) 6. Ground clamp 7. Antenna lead-in wire Do not stack or place nearheat source Warning: Do not install this device on top of any other electrical equipment or install any other equipment on top of this device. Keep this device away from any heat sources such as direct sunlight, heaters, radiators, or other A/V receivers or devices that emit heat. This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union, this product should be treated and recycled in accordance with the laws of your jurisdiction implementing the WEEE Directive. © 2009 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarksof NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks orregistered tra...