Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
14. Test for leakage. 5/7 General maintenance Clean aerator periodically. Do not use harsh detergents, solvents, chemical agents, metallic sponges, etc. that could harm the surface. Clean only with a soft sponge and soapy water. Clean and dry the faucet properly in case of hard water deposits which could damage the surface. Replacing the spray flex hose 1. Shut off the water supply to the faucet. 2. Pull the spout outwards from its place and unscrew the aerator . 3. Unscrew the hand shower from the flex hose by means of a 10mm key, keeping the flex hose firm with a 13mm wrench. 4. Disassemble the joint and pull out the disassembled flex hose. 5. Reassemble following the directions in reverse. Key 13 mm Key 10 mm Key 10 mm 6/7 Limited lifetime warranty Franke Consumer Products, Inc., Kitchen Systems Division extends the following warranty to the original purchaser of its faucets effective January 1, 2003. All faucets installed in a private residence will carry a limited lifetime warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage. All chrome finishes carry a limited lifetime warranty; all other finishes are warranted for five (5) years form the original date of purchase. Marine Installation: All products in a marine installation will carry a limited lifetime warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage. All chrome products carry a limited lifetime warranty on the finish; all other finishes carry a three-year (3) warranty from the original date of purchase. This warranty applies only to the original owner, providing the product has been installed in accordance with our installation instructions, used as recommended and in a normal residential application. In the event of a warranty claim, the owner will be required to provide proof of purchase - save sales receipt. This warranty covers all components which make the product operational. Franke, at its option, may repair or replace the product or components necessary to restore the product to good working condition. Franke reserves the right to inspect the installation prior to the actual replacement of the product or component part. This warranty does not cover misuse or abuse, accidental damages, scuffs or scratches, improper installation, abnormal usage, negligence or damage caused by improper maintenance or cleaning. Normal wear of parts is excluded from the warranty. Damage caused by impurities or acts beyond our control are not covered. Any product or part which has been repaired or altered in any manner outside of Franke’s factory, unless previously authorized in writing by Franke, will void warranty. Any replacement excludes transportation and any labor re-installation costs. This warranty does not allow recovery of incidental or consequential damages such as loss of use, delay, property damage or other consequential damage, and Franke accepts no liability for such damages. The Franke warranty is limited to the above conditions and to the warranty period specified herein and is exclusive. Franke DISCLAIMS all other warranties, expressed or implied, including IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR AS PARTICULAR PURPOSE. This warranty gives you specific legal rights that may vary from state to state. Further information For any further information about our products, about the installation of them or about the guarantee, please dial the number of the customer service: Phone number +1-215-822-6590 Or: 1-800-626-5771 Fax number + 1-215-822-5873 Franke Consumer Products Inc. - Kitchen Systems Division 3050 Campus Drive, Suite 500 Hatfield, PA 19440 7/7 FRANCAIS PARTS DE RECHANGE G 905.XX Poignee G R0239.XX Anneau de fixage G 1156 Cartouche G R0498 Set de fixage (Anneau de caoutchouc, bride triangulaire , bride metallique, ecrou filete) G R01643 Flexible pour la douchette G 1644 Contrepoids en plomb G 1782 Flexibles de alimentation G 1642.XX Brise-jet DONNEES TECHNIQUE Consommation maximum d’eau : 2.2gpm 60PSI Intervalle conseille de pression : 25-100 PSI – au-dela de 100 PSI est recommendee un reducteur de flux. Conformee a Proposition 65, NSF 61, UPC et C-UPC conditions. 1/7 Installation du melangeur 1. Deballer tous les elements et verifier qu’ils soient tous presents (voir le tableau et l’image specifies). NOTE: Communiquer immediatement tout manque ou defaut. (1-800-626-5771) ou visite TABLEAU DE CONTENU 1 Melangeur 2 Set de fixage (Anneau de caoutchouc, bride triangulaire , bride metallique, ecrou filete) 3 Cle hexagonal 4 Contrepoids en plomb 2/7 2. Retirer tous les elements necessaire pour le montage du sachet en plastique. 3. Inserer le grand joint dans le pied du mitigeur et placer le meme NOTE: Le joint en caoutchouc doit etre insere entre le plan du lavabo et le corps du mitigeur. N’UTILISEZ PAS de mastic, ou autre produit pour cette operation 4. Installer les elements de montage...