Stimmen - 4, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Hans Grohe Dateigröße: 5.29 mb Dateiname: hruh0136.pdf Unterrichtssprache:

This panel incorporates a thermostatic mixing valve. The high temperature limit stop on the mixing valve can be reset to comply with local plumbing codes. See page 10. *Know and follow all applicable local plumbing codes when setting the temperature on the water heater. Preparation for Installation Install 1/2” IPS nipples for the hot and cold water supplies at the locations shown on the diagram. The nipples should extend 5/8” outside the surface of the finish wall. For proper operation of the unit, the hot supply should be on the left, and the cold supply should be on the right. Install the wall surface material. Make sure that the wall is watertight before installing the panel. Seal the wall around the nipples with waterproof sealant. Installation Wrap the nipples with several layers of Teflon tape. Install the elbows included with the panel. The outlets should point downwards. The elbow should extend no more than 1 1/4” from the surface of the finished wall. With a helper holding the panel in place, mark the positions of the screw holes. Set the panel aside, securely supported to prevent damage. Drill the screw holes with a 6 mm bit suitable for the wall surface. Install the anchors. Seal the wall around the anchors with waterproof sealant. Hold the panel against the wall. Install the gray plastic insert. Insert the top screw through the front of the panel, the washer and the insert. Screw it into the anchor. Install the center and bottom screws and washers. Connect the supply hoses to the hot and cold supply elbows. Connect the supply hoses to the hot and cold inlet ports on the valve. Turn the water on at the main. Push the diverter stem up to turn the water on to the panel. Check all connections for leaks. Once you ensure that the connections are watertight, push the diverter stem down to turn the water off to the panel. Install the side seals on the front cover. Trim off any excess. Push the front cover into place. Install the diverter sleeve. Make sure that the indexing mark on the thermostatic mixer sleeve is at the 12:00 position. Install the thermostatic mixer handle. Tighten the handle screw with a flat-bladed screwdriver. Install the diverter handle. Tighten the set screw with a 4 mm Allen wrench. Place a black rubber washer in one end of the handshower hose. Screw this end of the hose to the handshower outlet port. Place the screen washer in the other end of the hose. Screw this end of the hose to the handshower. Place the handshower in the holder. Adjust the Slider You can make the slider easier or harder to move. Use a 2.5 mm Allen wrench to turn the set screw clockwise to increase the tension, counter-clockwise to decrease the tension. Justify the Thermostatic Mixer Handle Turn the water on to the handshower. Turn the thermostatic mixer handle until the output water measures 100o on a thermometer. Turning the handle clockwise makes the water cooler, counter-clockwise makes the water warmer. Turn the water off. Loosen the thermostatic mixer handle screw. Remove the handle. Replace the handle so that the safety stop override button is at the 12:00 position. Tighten the set screw. Set the High Temperature Limit Stop (optional) Remove the thermostatic mixer handle. Remove the clip and the stop ring from the stem of the thermostatic mixer. Turn the water on to the handshower. Turn the temperature control stem until the output water is the desired maximum high temperature -- usually 110o*. Turn the water off. Replace the stop ring so that the tooth is against the high temperature limit stop. Replace the clip. Justify the han...

Herunterladen

Geben Sie zwei Ziffern: