Stimmen - 3, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Dometic Dateigröße: 404.06 kb Dateiname: 00600344934EN.pdf Unterrichtssprache:

Also, to maintain optimum efficiency in odor control, the waste holding tank should be cleaned thoroughly at least once or more each season depending on use. Why Not use Household Toilet paper in Your Toilet. Household tissues often contain adhesives which bond together the paper fibers from which the tissue is made. The adhesives prevent the tissue from breaking apart, and their use in “ultra-low flow” systems can cause system clogging. SeaLand tissue is especially designed for use in low water toilet systems. Its rapid dissolving properties minimize the amount of residual paper in the holding tank and allow deodorizers to work more efficiently. SeaLand brand versus other brands. We constantly strive to provide our system owners with effective products that have minimal environmental impact and good value. Many deodorant products do not measure up to our standards of performance and value. SeaLand® Rapid-DissolvingToilet Tissue Four 400-sheet rolls part No. 379441204 SeaLand® Liquid Deodorant Environment friendly 32-oz. bottle part No. 379114032 SeaLand® Cleaner 6-oz. bottle part No. 379314016 5 TRoubLESHooTING GuIDE SEALAND ToILET bASE ASSEMbLY bAND CLAMp fASTENER fLuSH bALL SpRING CARTRIDGE WATER VALVE ASSEMbLY Top VALVE CAp fILTER SCREEN WATER VALVE SCREWS VALVE boDY SHAfT fLuSH pEDAL pEDAL CoVER bAND CLAMp SEAL DISK SEALAND ToILET boWL, REAR VIEW VACuuM bREAKER WATER VALVE HoSE CoNNECTIoN HAND SpRAYER HoSE CoNNECTIoN* STRAIN RELIEf bRACKET* * Applies only to toilet models supplied with hand sprayers. VACuuM bREAKER/boWL CoNNECTIoN problem possible Cause Service Instructions 1. Toilet emits odor (flush ball open). a. b. Odor emitting from base of toilet. Plugged holding tank vent line. a. Use SeaLand brand deodorants. b. Clear obstruction from vent line. 2. Water will not stay in bowl. a. b. c. d. Loose band clamp. Improper seal around flush ball due to dirt or debris on flush ball. Worn or damaged seal. Worn or damaged flush ball. a. Tighten band clamp fastener. b. Inspect flush ball for foreign debris. Clean flush ball if needed. c. Replace seal. d. Replace flush ball. 3. Flush ball will not close completely. a. b. Too much friction between flush ball and ball seal. Water valve screws are too tight. a. Lubricate between flush ball and seal with lubricant (e.g. silicone spray, furniture polish). b. Loosen screws slightly. 6 TRoubLESHooTING GuIDE (cont’d) problem possible Cause Service Instructions3. Flush ball will not close completely. (continued) c. Defective spring cartridge. c. Check spring tension by pushing flush lever down, then release it suddenly. If lever does not snap back to original position, replace spring cartridge. 4. Flush ball will not open. a. b. Broken shaft. Shaft not fully engaged in the spring cartridge. a. Replace shaft. b. Rotate flush ball slightly until shaft lines up with square in spring cartridge and is fully engaged. 5. Water does not shut off in toilet (toilet overflows). a. b. Worn or defective water valve. Worn or defective spring cartridge. a. Replace water valve. b. Replace spring cartridge. 6. Hand spray unit leaks. a. Hand sprayer is defective. a. Replace hand sprayer. 7. Water does not enter toilet bowl properly. a. b. c. Insufficient water flow rate at toilet. Water valve clogged. Plugged rim wash holes in toilet. a. Check water flow rate at toilet. Rate should be 2 gpm (7.6 lpm) at toilet. b. Remove and clean screen located on water valve. c. Clean holes. If still a problem, replace toilet bowl. 8. Water is leaking from water valve. a. b. c. d. Water valve body cracked due to freeze damage. Water line connection is loose or not seated properly. Defective water valve. Stripped threads. a. Replace water valve. b. Insure that threads are not cross-threaded and tighten. c. Replace water valve. d. Replace water valve. 9. Water is leaking from bottom of toilet base. a. b. c. d. Toilet is not secured to floor. Worn or defective toilet mounting floor seal. Cracked base. Worn or defective floor flange. a. Tighten toilet mounting bolts. b. Replace floor seal between floor flange and toilet base. c. Replace base assembly. d. Replace floor flange. 0. Water is leaking from rear of toilet bowl. a. b. c. Worn or defective vacuum breaker. Loose vacuum breaker. Cracked or defective toilet bowl. a. Remove white cap from vacuum breaker. Flush toilet. If water leaks during flush, vacuum breaker needs to be replaced. b. Secure vacuum breaker connection. If loose, push breaker into bowl. c. Replace toilet bowl. . Water is leaking from the base/toilet connection. a. b. Band clamp may be loose. Ball/bowl seals may be worn or defective. a. Remove plastic base cover (on applicable models) and tighten band clamp fastener. b. Replace ball/bowl seals. 7 MANufACTuRER’S 2-YEAR AND 10-YEAR LIMITED WARRANTY Dometic Corporation warrants, to the original purchaser only, that this SeaLand® gravity discharge toilet, if used for personal, family or household-like purposes, is free from defects in ma...

Herunterladen

Geben Sie zwei Ziffern: