Stimmen - 4, Durchschnittliche Bewertung: 4 ( )

Hersteller: Axor Dateigröße: 1.2 mb Dateiname: hruh0147.pdf Unterrichtssprache:

These strips must be removed before the spout is installed. Loosen the spout screw with a 2.5 mm Allen wrench.Pull the spout away from the escutcheon. Remove the adhesive strips. Reassemble the spout assembly so that the hole for the pull rod is at the rear of the spout. adhesive strips Installation Remove the valve mounting nuts from the valves. From below the mounting surface, push the valves up into the holes. Install the mounting nuts on the valves. Tighten the tensioning screws. Place the handles over the valve mounting nuts. Tighten the handles by rotating the escutcheons clockwise. The handles should be parallel to the basin. If necessary, loosen the tensioning screws and rotate the valve slightly. Install the spout. Rotate the spout escutcheon if necessary, so that the hole for the pull rod is at the rear. Tighten the mounting nut. Tighten the tensioning screws. Screw the connecting hoses into the spout tee. Slide the 3/8" compression nuts and ferrules over the ends of the hoses. Connect the hoses to the valve outlets. Use two wrenches so that the hoses do not twist or become loosened from the spout tee. Install the supply lines (not included). Install the drain. Turn on the water and check all connections for leaks. Install the pop-up drain Remove the plunger assembly. Unscrew the drain outlet flange from the tee. Unscrew the tailpiece from the tee. Wrap the threads with two layers of Teflon tape and replace. Install the white, flexible sealing gasket on the flange. Place it in the sink outlet. From under the sink, install the black mack gasket, white friction ring and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time. Thread the tee and tailpiece to the flange. The pivot must face the faucet. If necessary, turn the drain assembly. Tighten the retainer nut. Place the plunger assembly in the drain. Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster. Install and hand tighten the pivot ball nut. Attach the swivel connector to the end of the horizontal rod. Attach the swivel connector to the end of the pull rod. Position as desired and tighten with a small, flathead screwdriver. plunger height adjuster flange sealing gasket mack gasket pull rod friction ring retainer nut tee pivot ball nut tailpiece horizontal rod swivel connector User Instructions Turn the right handle forward (clockwise) to turn the cold water on. Turn the handle back (counter- clockwise) to turn the cold water off. Turn the left handle forward (counter-clockwise) to turn the hot water on. Turn it back (clockwise) to turn the hot water off. Replacement Parts 10 13 15 14 7 8 11 1 12 4 9 2 1 handle - hot 97503XX0 handle - cold 97502XX0 2 valve set 97960001 3 hot cartridge 94009000 4 cold cartridge 94008000 5 connection hose 94071001 6 3/8" compression ftg 88513000 7 aerator 13085000 8 pull rod 96657XX0 9 spout mounting kit 13961000 10 spout 97504XX0 11 spout escutcheon 97505XX0 12...

Herunterladen

Geben Sie zwei Ziffern: