Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Axor Dateigröße: 4.6 mb Dateiname: hruh0107.pdf Unterrichtssprache:

Push the end of the hose into the valve outlet. Tighten the compression nut wrench tight. Do not allow the connecting hose to twist, or it will become loosened from the spout. Repeat with the second connection hose. Install the handles Swing C, Tango C, Limbo C only: Install the deco-rings on the handles All models: Hold the lever in the desired “off” position with one hand. With the other hand, turn the bell clockwise, so that it threads down over the valve stem. Install the pull rod Solaris E, Stratos E, Metro E, and Swing C only: The pull rod is curved. It should be installed with the curve as shown in the diagram. Tango C and Limbo C only: The pull rod is straight. Finish the installation Install the pop up drain. Install the supply lines (not included) according to the manufacturer’s directions. Turn on the water and check for leaks. Install the Pop Up Drain Remove the plunger assembly. Unscrew the drain outlet flange from the tee. Unscrew the tailpiece from the tee. Wrap the threads with Teflon tape and replace. Install the flexible sealing gasket to the flange. Sit it in the sink outlet. From under the sink, install the black mack gasket, white friction ring, and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time. Thread the tee and tailpiece to the flange. The pivot must face the faucet. If necessary, turn the drain assembly. Tighten the retainer nut. Sit the plunger assembly in the drain. Install the horizontal rod through the pivot ball seals and into the tee so that the end goes through the loop in the bottom of the height adjuster. The two pivot ball seals should surround the pivot ball. Slide the link over end of pull rod. Tighten screw. Slide one end of spring clip over end of horizontal rod. Slide link over end of horizontal rod. Test motion of drain plunger. Reposition link as necessary. There are multiple holes in the linkage -- the horizontal rod may go through any of the holes. When satisfied with the action of the drain, slide the other end of the spring clip over the end of the horizontal rod. plunger height adjuster flange sealing gasket link mack gasket spring clip friction ring retainer nut nut horizontal rod pivot ball pivot ball seals pivot tee tailpiece Robinets de lavabo Limbo C Tango C Swing C Solaris E Stratos E Metro E A prendre en consideration pour l’installation Pour de meilleurs resultats, Hansgrohe recommande que ce produit soit installe par un plombier professionnel licencie. Veuillez lire attentivement ces instructions avant de proceder a l’installation...A....... A.......Assurez- vous de disposer de tous les outils et du materiel necessaires pour l’installation. Donnees techniques Pression d’eau recommandee........... ..........22 -72 psi Temperature recommandee pour l’eau chaude.............. .............120° – 140°F* Dimension du trou dans la surface de montage. Robinets....... 1 . po bec......... 1 3/8 po Epaisseur maximale de la surface de montage....... 1 . p...

Herunterladen

Geben Sie zwei Ziffern: