Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Axor Dateigröße: 1.23 mb Dateiname: hruh0100.pdf Unterrichtssprache:

Drill the holes with a 6mm bit. Install the anchors. Install the mounting piece with the notch at the bottom. Do not press the mounting piece into the accessory until the mounting piece is screwed firmly to the wall! If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. 06097 Towel bar only: Press the end pieces over the mounting pieces (1). Use the enclosed allen wrench to tighten the set screws (2) Other accessories and towel bars: Press the accessory firmly over the mounting piece. The retaining pin in the accessory will snap into place, holding the accessory firmly on the mounting piece. To remove the accessory from the wall 06097 Towel bar only: Use the allen wrench to loosen the set screw (1). Pull the accessory away from the wall (2). All other accessories and towel bars: Push a small tool, such as an allen wrench, through the hole in the bottom ot the escutcheon. Push the tool firmly against the retaining pin (1). At the same time, pull out on the holder (2). Installation 06096XX0, 06099XX0 Drill the hole using a 6 mm bit suitable for the wall surface. Install the anchor. Screw the mounting piece to the wall. Screw the hook to the mounting piece. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. Accessories E Tumbler 06589XX0 Soap Dish 06592XX0 Soap Dispenser 06593XX0 Toilet Paper Holder 06596XX0 Toilet Brush 06600XX0 12” Towel Bar 06598XX0 24” Towel Bar 06866XX0 Face Cloth Hook 06594XX0 Robe Hook 06595XX0 Installation 06593XX0, 06589XX0, 06592XX0, 06600XX0 Mark the positions of the screw holes on the wall. Drill the screw holes using a 6 mm drill bit. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. Screw the support into the anchors. The pin on the support should be on the bottom. Slide the cover over the support. The pin on the support clicks into place in the hole in the cover. Place the accessory into the holder. The accessory may be removed from the holder. Installation 06596XX0 Mark the positions of the screw holes. Drill the screw holes using a 6 mm bit suitable for the wall surface. Install the anchors. Screw the support into the anchors. Slide the toilet paper holder over the support. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to possible water damage. Installation 06594XX0, 06595XX0 Mark the positions of the screw holes on the wall. Drill the screw holes with a 6 mm drill bit Install the anchors. Screw the hook into the wall. Slide the screw cover against the wall. If the accessory is installed in the shower, seal the wall around the anchors with waterproof sealant. Failure to seal the wall can lead to pos...

Herunterladen

Geben Sie zwei Ziffern: