Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Dixon Dateigröße: 3.7 mb Dateiname: Unterrichtssprache:

The rotation direction when zero turning is determined by which steering control is moved backward behind the neutral position. If the left steering control is pulled backward, the machine turns to the left. Use extra care when using this maneuver. Tracking If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi (1 bar). Tracking must be checked on a flat and level concrete or blacktop surface. If unit still does not track straight, contact a Dixon dealer for adjustment. Steering controls A WARNING! The machine can turn very rapidly if one steering control is moved much further forward than the other. 1. Forward 2. Neutral 3. Neutral slot, Neutral lock 4. Reverse Motion control lever pattern (right side) English-18 CONTROLS 2. Seat adjustment lever The seat can be adjusted lengthways. When making adjustments, sit on the seat. Slide the lever to the side and maneuver seat to appropriate placement and release lever. 3. Unlocking Transmission When pushing or pulling the mower, be sure to engage the IZT (Integrated Zeroturn Transaxle) bypass linkages. • Always turn off engine before engaging or disengaging the hydro release (free wheel) lever. Never attempt to move the lever with the engine running. • Lift the seat to access release levers. Push the hydro release levers toward the rear of the machine and inward until notches lock in place on frame. Release park brake. • To engage the transmissions, move the release levers outward so they return to normal position. 8050-165 Seat adjustment 8050-767 Bypass linkages IMPORTANT INFORMATION Before pushing or towing tractor, transmission must be unlocked and park brake released. The tractor should never be pulled at more than 2 miles per hour (3.2 km/h) or for distances over % mile (.402 km). Trailer the unit for distances over % mile. English-19 CONTROLS 4. Refueling The machine has one fuel tank, just behind the seat. The tank capacity is 4.5 gallons (17 liters). The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See also Technical Data concerning ethanol fuel. Methanol fuel is not allowed. When operating below 32°F (0°C) use fresh, clean winter grade gasoline to help insure good cold weather starting. WARNING! Gasoline is highly flammable. Observe caution and fill the tank outdoors. (See Safety) 8050-768 Fuel tank A WARNING! Fill to the bottom of the filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame. WARNING! The engine and the exhaust system, become very hot during operation. Risk for burns if touched. Allow engine and exhaust system to cool at least two (2) minutes before refueling. IMPORTANT INFORMATION Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur. English-20 CONTROLS 5. Ignition Switch The ignition key is placed on the driver’s panel and is used to start and stop the engine. IMPORTANT INFORMATION Do not run the starter for more than five seconds each time. If the engine does not start, wait about 10 seconds before retrying. 6. Choke Control The choke is used for cold starts to provide the engine with a richer fuel mixture. Two choke options are available, depending on model. For units with a separate choke control, pull the choke control knob up. For units with choke/throttle combinations, push the throttle control all of the way forward into the indicated slot. 7. Throttle Control The throttle control regulates the engine speed and thereby the rate of rotation of the blades, assuming the blade switch is pulled out, see Engaging the Mower Deck. In order to increase or decrease the engine speed, the control is moved. Avoid idling the engine for long periods, as there is a risk of fouling the spark plug. USE FULL THROTTLE WHEN MOWING, for best mower performance and battery charging. Ignition switch Choke control and throttle control English-21 CONTROLS 8. Blade switch In order to engage the mower deck, pull the knob out; the mower blades are disengaged when the knob is depressed. 9. Circuit breaker The circuit breaker provides protection for the electrical system by (1) 15 amp circuit breaker. If the circuit breaker trips, push the button to reset. If the condition repeats, consult a dealer for inspection and repair. 10. Parking Brake ...

Herunterladen

Geben Sie zwei Ziffern: