Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Electrolux Dateigröße: 1.2 mb Dateiname: Unterrichtssprache:

• Store the fuel in a cool, well-ventilated place, in an approved fuel storage container. • Never store the engine with fuel in the tank in a poorly ventilated place where the fumes produced by the gasoline could propagate and reach a fire, candle, burner or furnace pilot light, water heater, dryer, etc. • The fumes produced by the fuel can cause an explosion or fire. • Never store excessive quantities of fuel. • To prevent problems in starting the engine again, we recommend that you never let the machine run completely out of fuel. E. Cutting procedure any reason without the certainty that the accidents. height. down. release knob (E), has returned to its original position with the grip correctly locked. CAUTION! Before using the machine, make sure the rear grip is firmly locked in one of the proper positions so as to prevent CAUTION! If the grip does not remain locked in one of the three positions, take the machine to an Authorized Service Center. The horizontal cutting position is used to even the tops of bushes, shrubs and hedges. • Always cut from right to left. • Never use the hedge trimmer above shoulder The vertical cutting procedure is used to trim the sides of shrubs, bushes and hedges. • Always cut upward from the bottom. • Hold the machine with both hands. ess the trigger of the butterfly valve all the way during cutting operations. • When you have finished, release the trigger on the butterfly valve and wait for the engine to idle; the blade should stop. • Move on to the next section. • After reaching the next section and taking a stable standing position, resume working by pressing the trigger on the butterfly valve all the way ENGLISH - 5 F. Starting and stopping the engine CAUTION! • Before starting the machine read this manu- CAUTION! To start the machine correctly and safely, use the following procedure: • Place the machine on the ground in a flat, stable position • Grasp the starter knob with one hand and use the other to hold the machine steady on the ground (Note: do not wind the starter cord around your hand) and pull gently until you feel some resistance, then pull the cord sharply and forcefully (to start the engine when warm or cold see the instructions below. CAUTION! Do not pull the starter cord all the way to the limit and do not let it snap back against the machine as this could damage it. COLD ENGINE Place the stop switch on "I" or "START" n the choke control to the START position. Pump by squeezing the bulb (C) several times until you see the fuel flow back into the tank ough the hose (D). Grasp the starter knob properly and pull the start cord until you the engine starts to catch. ess the accelerator trigger (A), and safety lever (B) all the way, the choke control (C) automatically returns to its original position. 5 Pull the cord until the engine starts. 6 To stop the engine press the stop switch to bring it to the "0" or "STOP" position. WARM ENGINE 1 Place the stop switch on "I" or "START" 4 Make sure the choke ...

Herunterladen

Geben Sie zwei Ziffern: