Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Troy-Bilt Dateigröße: 2.07 mb Dateiname: Unterrichtssprache:

Empty housing without shafts, gears, seals, dipstick, etc. Call Factory before ordering....................... 24 1909157 Dipstick-oil, tiller attachment..... 13 MODELS 12068, 12069, 12070, 12071, 12087, 12087C, 12088, 12088C, 12089, 12089C,12090, 12090C BOLO TINE ASSEMBLIES (Figure 8) 14 MODELS 12068, 12069, 12070, 12071, 12087, 12087C, 12088, 12088C, 12089, 12089C, 12090, 12090C REF No. PART No. DESCRIPTION QTY. STANDARD TILLING TINES 2 3 4 5 6 1270-1A 1901975010 Tine Holder-welded steel, fits left or right sides...................... 2 1982612 Bolt-hex hd„ 3/8-16x2"............. 4 This Ref. No. not used................. This Ref. No. not used................. This Ref. No. not used................. Bolo Tine-single, left hand. Used on left and right side tine assy. Tine is stamped either “EL" or “AL". (Incl. two each of Ref. No.’s 8 and 10)................................. 8 1270-2A Bolo Tine-single, right hand. Used on left and right side tine assy. Tine is stamped either “ER" or “AR”. (Incl. same hardware as Ref. No. 6)............................... 8 Bolt-hex hd., 3/8-16x1"............. 16 This Ref. No. not used................. 1733398 Locknut-hex, 3/8"-16.................. 20 1901118 Tine Replacement Kit-unassembled (Incl. eight each of Ref. No.’s 6, and 7, sixteen each of Ref. No.'s 8 and 10). Includes easy-to-follow installation instruction. DOES NOT INCLUDE tine holders, holder mounting hardware, or tine shaft keys................................. 1 8 1100046 9 10 REF No. PART No. DESCRIPTION QTY. CUSTOM TILLING TINES Special hard-faced, high-chrome carbon alloy tines that are thicker than standard Bolo Tines. These tines better resist the abrasive action of rocky, gritty or sandy soil as compared to standard Bolo Tines, and are especially suited for custom tilling or market gardening. 10802 Custom Tilling Tine Kit—(Incl. eight each of Part #2475-1 and #2475-2 tines and sixteen each of Ref. No.’s 8 and 10...... 1 2475-1 Bolo Tine, Custom Tilling—single, left hand................................... 8 2475-2 Bolo Tine, Custom Tilling—single, right hand................................ 8 15 MODELS 12068, 12069, 12070, 12071, 12087, 12087C, 12088, 12088C, 12089, 120890,12090, 12090C ELECTRIC START SYSTEM - 7HP & 8HP TILLERS (Figure 9) MODELS 12068, 12069, 12070, 12071, 12087, 12087C, 12088, 12088C, 12089, 120890,12090, 12090C REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 96515 Cable—battery, positive and negative 22 This Ref. No. not used................. terminals.................................. 2 23 9265 Tie-plastic, wire retaining............ 1 2 97020 Boot-terminal insulating............. 3 24 9009 Vent Tube-5/16” diameter........... 1 3 9552 Screw-self-threading, 25 1475 Shield-venttube, 1/2" diameter... 1 1/4-20x1/2"............................ 3 26 9224 Clamp-vent tube shield............... 1 4 1186309 Bolt-hex hd., 1/4-20 x 5/8".......... 2 27 9202 Tie-plastic................................... 2 5 1554 Wire-recharge (red) for Briggs 28 1908118 Wire Harness & Connecting and Stratton engine (incl. Terminal Assy-for Briggs & Stratton terminal and eyelet)................. 1 engines(available as 6 1904564 Battery Hold-down Clamp-with attached Key Switch Plate (incl. Ref. No. 7)............................... 1 complete assembly only). Incl. wire assy., w/connector to large solenoid stud (red wire); wire 7 1904548 Decal-ignition switch instruc....... 1 assy, w/connector to small 8 1908112 Key Switch-includes two ignition keys (Ref. No. 9), one lockwasher, and one mounting solenoid stud (red wire); wire assy, w/connector to solenoid grounding screw (red wire); wire nut (lock-washer and nut not assy w/connector to engine ground available separately)................. 1 shut-off (green wire); plastic 9 96520 Key-ignition, one pair.................. 1 protector tube; wire harness; 10 9566 Bolt-carriage, 1/4-20 x 1-1/4"..... 2 connector; wire terminal.......... 1 11 1100241 Lockwasher-spring lock, 1/4"...... 2 29 1908117 Wire Harness-for Kohler engine. 12 1186229 Nut-hex, 1/4--20......................... 4 Incl. two receptacles; three red 13 9092 B Battery-12 volt, 30 amps., side-vented. (incl. Ref. No. 24)........ 1 wires (solenoid activate, battery recharge, and starter switch); 14 96514 Solenoid—starter, includes nuts and washers for cables and wires... 1 two green (ground)(shutoff) wires; plastic harness tube....... 1 15 1100242 Lockwasher-5/16"....................... 2 30 1186389 Locknut-hex, 1/4'-20.................. 2 16 1186211 Nut-hex, 5/16"-24....................... 2 31 20421 Wire-ground............................... 1 17 1187559 Lockwasher-external tooth, #10.. 1 32 1901202 Cabie-ground, solenoid to engine 18 1186208 Nut-hex, #10-32.......................... 1 block........................................ 1 19 96510 Cable...

Herunterladen

Geben Sie zwei Ziffern: