Login:
heruntergeladen wurde: 1   Dateigröße: 241 kb   Hersteller: DeWalt  
Kategorie: Jack Planes
@name

CAUTION: Allow the tool to reach full speed before touching tool to the work surface. Lift the tool from the work surface before turning the tool off. The rabbet fence can be installed on either side of your The planer can make rabbet cuts up to 12 mm. 5 To Install Rabbet Fence 1. Loosen the rabbet fence adjustment knob (G). 2. Slide the crossbar on the rabbet fence (F) into the hole near the front of the planer as shown in Figure 5. 3. Securely tighten rabbet fence adjustment knob (G) as shown

heruntergeladen wurde: 22   Dateigröße: 241 kb   Hersteller: DeWalt  
Kategorie: Jack Planes
@name

Adjusting Planing Depth (Fig. 1) WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/ installing attachments or accessories. Planing depth is infinitely variable from 0 to 2.5 mm. To adjust the cutting depth, rotate the depth adjustment knob/front handle (C) clockwise from the “0” position. Each click of the adjustment knob represents approximately 0.1 mm of depth. The cutting depth will increase fr

heruntergeladen wurde: 8   Dateigröße: 2 mb   Hersteller: DeWalt  
Kategorie: Jack Planes
@name@name@name

D-2 Fig. D-1 6 - English FUNCTIONAL DESCRIPTION FUNCTIONAL DESCRIPTION FOREWORD The Delta JT360 6" (152mm) Jointer with Stand is designed with a cutting capacity of 6" (152mm) width, 1/2" (13mm) depth and rabbeting 1/2" (13mm). Unit includes; heavy-duty 3/4 hp, 115/230 volt induction motor, stand, dust chute, center-mounted fence, three-knife cutterhead, cutterhead guard, and push blocks NOTICE: The manual cover illustrates the current production model. all other illustrations are representative

heruntergeladen wurde: 3   Dateigröße: 855 kb   Hersteller: DeWalt  
Kategorie: Jack Planes
@name@name@name

1. True Up One Face – Feed one face of the board through a jointer. Make thin cuts with each pass until the entire surface is flat. 2. Plane to Thickness – Place the surfaced side (STEP 1) face down and feed the board through a planer until the opposite side is flat. Plane both sides of the board until you achieve your desired thickness. Make thin cuts, alternating sides with each pass. If, during the planing operation, you notice the board twisting, warping or bowing, start again with STEP 1. 3





Kategorien