|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
3 Press RECEIVER to enable receiver operation. You do not need to press RECEIVER if the other input buttons do not light up. 4 Press ON SCREEN. The menu list appears on the TV screen. Press MENU when the menu list does not appear on the TV screen. The menu appears on the TV screen when “GUI ON” appears on the display. 5 Press ./. repeatedly to select “Settings,” then press. . or. . The Settings menu list appears on the TV screen. 6 Press ./. repeatedly to select “Auto Calibration,” then press . 7 Press ./. repeatedly to select “Auto Calibration Start,” then press . 8 Press ./. repeatedly to select Position, then press. . or . You can register three patterns as position 1, 2, and 3, depending on the listening position, listening environment and measurement conditions. 9 Press .. Press ./. and repeatedly to un-check the items you do not want to measure. Speaker Distance Speaker Level Frequency Characteristic 10 Press to select “Start.” 11 The measurement starts in five seconds. 12 Measurement starts. The measurement process will take approximately 30 seconds. Wait until the measurement process completes. 13 The measurement is completed. When the measurement ends, a beep sounds and the measurement result appears on the TV screen. Tip The displayed unit of distance for models for US and Canada is feet. The unit of distance for models for countries/areas other than US and Canada is meters. You can change the unit of distance use in “Distance Unit” in the Auto Calibration settings menu. 14 Press to select “Next.” 15 Press. ./. repeatedly to select..Y................ “Yes,”............ then press . 16 Press ./. repeatedly to select the auto calibration type, then press . The measurement results are saved. Parameter Explanation Full Flat Makes the measurement of frequency from each speaker flat. Engineer Sets the frequency to one that matches that of the Sony listening room standard. Front Reference Adjusts the characteristics of all the speakers to match the characteristics of the front speaker. OFF Sets the auto calibration to off. 17 Press RETURN/EXIT.. The auto calibration start up screen appears. When error codes appear When “Auto calibration (auto speaker setup) complete, but an issue occurred. Confirm Issue?” appears on the TV screen in step 14, you can select whether to confirm the warning (“Yes”) or not (“No”). Follow the instructions of the TV screen when you select “Yes.” For details on warning and error codes, see “Message list after auto calibration measurement” in “9: Calibrating the appropriate settings automatically (AUTO CALIBRATION)” in the operating instructions. Note You cannot measure the speaker height of the surround speakers and the surround back speakers. Set this value from the surround position settings in the Auto Calibration. Tips The size of a speaker (LARGE/SMALL) is determined by the low characteristics. The measurement results may vary, depending on the position of the optimizer micro...