Stimmen - 1, Durchschnittliche Bewertung: 5 ( )

Hersteller: Linear Dateigröße: 798.29 kb Dateiname: Unterrichtssprache:

. A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users. Copyright © 2008 Linear LLC 218071 B USA & Canada (800) 421-1587 & (800) 392-0123 (760) 438-7000 - Toll Free FAX (800) 468-1340 D-67 DX-12 RELAY LATCH RESET BUTTON (MODEL D-67L ONLY) COMMON NORMALLY OPEN NORMALLY CLOSED ANTENNA RELAY OUTPUT TERMINALS COMMON NORMALLY OPEN NORMALLY CLOSED ANTENNA CONNECTOR SILVER (-) GOLD (+) POWER INPUT WIRES SILVER (-) GOLD (+) POWER INPUT WIRES CODING SWITCH CODING SWITCH SLOTS FOR MOUNTING BRACKET DX-12 FRONT FRONT BACK INSIDE RELAY OUTPUT TERMINALS D-67 CHOOSE A CUSTOM SECURITY CODE DO NOT USE THE FACTORY SET CODE USE A POINTED OBJECT TO SET ON/OFF POSITIONS FOR KEYS 1-8 OF THE CODE SWITCH NOTE: AVOID SETTING SWITCHES ALL ON, ALL OFF, OR IN AN ALTERNATING ON/OFF OR OFF/ON PATTERN MATCH THE CODE IN ALL TRANSMITTERS USED WITH THE RECEIVER FOR MULTI-CHANNEL TRANSMITTERS, REFER TO THE INSTRUCTIONS SUPPLIED WITH THE TRANSMITTER FOR SPECIAL CODING REQUIREMENTS DON'T SET THE SWITCH WITH A PENCIL OR PEN, THE SWITCH MAY BECOME CONTAMINATED MODEL LA-P 9" WHIP LOCAL ANTENNA (CONNECTS DIRECTLY TO THE RECEIVER) MODEL EXA-2000 DIRECTIONAL ANTENNA MODEL EXA-1000 OMNI-DIRECTIONAL ANTENNA SCREW THE ANTENNA'S CABLE INTO THE RECEIVER'S ANTENNA CONNECTOR ANTENNAS AVAILABLE FOR THE DX-12: NOTE: THE ANTENNA CABLE MAY BE EXTENDED UP TO 20 FEET, USE TYPE RG-59 CO-AX AND TYPE "F" CONNECTORS NOTE: SIGNAL LOSS FROM EXTENDING THE ANTENNA CABLE MAY REDUCE THE RADIO RANGE FOR D-67 RECEIVERS FOR DX-12 RECEIVERS ATTACH THE SUPPLIED MOUNTING BRACKET TO THE MOUNTING SURFACE NOTE: FOR BEST RADIO RANGE, MOUNT THE RECEIVER AS HIGH AS POSSIBLE, AWAY FROM OTHER RECEIVERS AND POSSIBLE INTERFERENCE SOURCES IMPORTANT: DO NOT MOUNT D-67 RECEIVERS INSIDE A METAL ENCLOSURE CLIP RECEIVER ONTO MOUNTING BRACKET STRAIGHTEN OUT ANTENNA WIRE USE APPROPRIATE FASTENERS TO SECURE THE RECEIVER TO THE MOUNTING SURFACE NOTE: DX-12 RECEIVERS MAY BE MOUNTED INSIDE A METAL ENCLOSURE AS LONG AS THE REMOTE ANTENNA IS LOCATED OUTSIDE OF THE ENCLOSURE 1. APPLY POWER TO THE RECEIVER. BE SURE THE ALARM CONTROL PANEL IS DISARMED OR IN A TEST MODE. 2. TRIGGER EACH TRANSMITTER CODED TO THE RECEIVER. THE RECEIVER RELAY SHOULD CLICK. VERIFY THAT THE PROPER ALARM CONTROL PANEL LOOP IS VIOLATED WHEN THE RECEIVER ACTIVATES. IF THE RECEIVER FAILS TO ACTIVATE, CHECK THE CODE SWITCH SETTINGS AND VERIFY THAT RECEIVER HAS POWER. 3. WITH PORTABLE TRANSMITTERS, OPERATE THEM FROM VARIOUS LOCATIONS TO DETERMINE THE USABLE RADIO RANGE OF THE SYSTEM. THIS WILL HELP TO LOCATE POSSIBLE TROUBLE AREAS WHERE METAL OR OTHER MATERIALS MAY SHIELD THE RECEIVER FROM THE TRANSMITTER. IMPORTANT: ELECTRONIC PRODUCTS ARE NO BETTER THAN THE INSPECTION AND MAINTENANCE THEY RECEIVE OVER TIME. THEREFORE, INSTALLERS SHOULD INSTRUCT THEIR CUSTOMERS TO TEST THIS EQUIPMENT REGULARY, AT LEAST ONCE A WEEK. + AUX OUTPUT C...

Herunterladen

Geben Sie zwei Ziffern: