Stimmen - 5, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
<-30 dB @ 5 MHz DC offset Audio (A) models.............. ±35 mV with input at 0 offset All other models................ <±20 mV with input at 0 offset Maximum resolution.................... 1920x1200 Refer to the user's manual for the maximum distances recommended for specific resolutions. Sync Input type (transmitter)..............................RGBHV, RGBS, RGsB, RsGsBs, bi-level or tri-level for component video Output type (receivers)................................RGBHV, RGBS, RGsB, RsGsBs Standards................................................................................NTSC 3.58, NTSC 4.43, PAL, SECAM Input level (transmitter) ............................3.5 V to 5.5 Vp-p, unterminated Output level (receivers)................................0.3 Vp-p for component video (bi-level sync) 0.6 Vp-p for component video (tri-level sync) TTL: 4.0 V to 5.0 V p-p, unterminated for RGBHV, RGBS Input impedance (transmitters) .. 573 ohms Output impedance (receivers)..........92 ohms ±8% (25 mA) Polarity Transmitter..................................................Positive or negative (follows input polarity) Receivers..........................................................Positive or negative (switch selectable) Extron MTP C7 15HD Series • Specifications 1 Specifications — MTP C7 15HD Series, cont'd Audio — MTP C7 T 15HD A, MTP C7 RL 15HD A, MTP C7 RL 15HD A SEQ Number/signal type..................... 1 set of proprietary analog signals Connector....................................... 1 female RJ-45 Gain................................................. Unbalanced output: 0 dB; balanced output: +6 dB Frequency response...................... 20 Hz to 20 kHz, ±1 dB THD + Noise.................................. 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level S/N.................................................. >70 dB at maximum output (unweighted) CMRR.............................................. >43 dB @ 20 Hz to 20 kHz Audio input — MTP C7 T 15HD A Number/signal type.................... 1 stereo, unbalanced Connectors .................................... (1) 3.5 mm mini stereo jack Impedance..................................... 10k ohms ±1%, unbalanced Nominal level................................ +4 dBu (1.23 Vrms), -10 dBV (316 mVrms) Maximum level............................. +12 dBu, (unbalanced) at 1%THD+N 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV « 2 dBu Audio output — MTP C7 RL 15HD A, MTP C7 RL 15HD A SEQ Number/signal type..................... 1 mono, balanced/unbalanced Connector ....................................... (1) 3.5 mm captive screw connector, 5 pole (uses 3 poles) Impedance...................................... 50 ohms balanced, 100 ohms balanced Gain error ....................................... ±1 dB channel to channel Nominal level................................ +4 dBu (1.23 Vrms), -10 dBV (316 mVrms) Maximum level.............................. >+18 dBm, unbalanced at 1% THD+N Control/remote — external device (pass-through, unidirectional or bidirectional) Serial control port input/output MTP C7 T 15HD RS.......... RS-232 via (1) 3.5 mm, 3 pole captive screw connector MTP C7 RL 15HD RS, MTP C7 RL 15HD RS SEQ 1 set of proprietary signals on a female RJ-45 jack Serial control port output/input MTP C7 T 15HD RS.......... 1 set of proprietary signals on a female RJ-45 jack MTP R 15HD RSA D......... RS-232 via 3 poles of a 3.5 mm captive screw connector, 5 pole The serial communications link is unidirectional only, transmitter to receiver, unless the receiver's directional DIP switch or jumper has been repositioned. The switch or jumper should be repositioned only when the receiver is the only one in the system. Baud rates)..................................... Up to 38400 bps at up to 600' (183 m) (Higher data rates and distances are possible. Performance will vary based on baud rate and cable length.) Protocol (all other models)........... Data bits = 5 - 8 Stop bits = 1 or 2 Parity = odd, even, none Flow control = XON, XOFF, none dsN Protocol is mirrored between the transmitter and the receiver. Serial control pin configurations. Captive screw connector: 1 = TX, 2 = RX, 3 = GND General Required cable type...................... CAT 7 External power supply................. 100 VAC to 240 VAC, 50/60 Hz, external; to 12 VDC, 2 A, regulated Power input requirements........... 12 VDC, 0.5 A 2 Extron MTP C7 15HD Series • Specifications Temperature/humidity................ Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing Cooling........................................... Convection, no vents Mounting Rack mount........................ Yes, with optional 1U, 9.5" deep rack shelf (RSU 129, #60-190-01 or RSB 129, 60-604-01); 1U, 6" deep rack shelf (RSU 126, #60-190-10 or RSB 126, 60-604-10); or VersaTools® 1U, 3.5" deep rack shelf (RSF 12...