Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
................ ............ ................ ......,...... .. ..... • . . . . . . . . . . . . . . . . . . . . . . . . . ..... • ............... .. .... • ................. ....... .... • ................. ....,...... .. .. • . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ( . . ) . . . . . , . . . . . . . . .... • ...........,........ .........,.............. ..... • ...., .....,...... .. • ................. ..... ........................ .............. ... • .............,....... ......... ............. ... • ................ ..... ................ ....... ........ FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The Class A limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. N This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance with FCC emissions limits. SW6 VGA Audio • Table of Contents Chapter One • Introduction ..................................................... 1-1 About the SW6 VGA Audio Switcher................................... 1-2 Chapter Two • Installation and Operation .................... 2-1 Mounting the Unit ..................................................................... 2-2 Tabletop placement ................................................................ 2-2 Rack mounting ........................................................................ 2-2 UL requirements ......................................................................2-2 Mounting instructions ............................................................2-3 Under furniture mounting ..................................................... 2-4 Connections .................................................................................. 2-5 Audio connections .................................................................. 2-7 Operation ...................................................................................... 2-8 Controls and indicators .......................................................... 2-8 Switch modes ........................................................................ 2-10 Determining the switch mode ..............................................2-10 Selecting a switch mode .......................................................2-10 Audio level control ............................................................... 2-11 Adjusting the audio level .....................................................2-11 Resetting all audio levels ......................................................2-12 Chapter Three • Remote Control ......................................... 3-1 Simple Instruction Set Control ............................................... 3-2 Host-to-switcher communications ......................................... 3-2 Switcher-initiated (unsolicited) messages ............................. 3-3 Err or responses ....................................................................... 3-3 Timeout ................................................................................... 3-3 Using the command/response table ...................................... 3-4 Symbol definitions ..................................................................3-4 Command/response table for SIS commands ........................3-5 Windows®-Based Program Control ....................................... 3-6 Installing the software ........................................................... 3-6 Using the software ................................................................. 3-7 Using the help system ............................................................ 3-7 Contact Closure Remote Control ........................................... 3-8 IR 102 Infrared Remote Control ............................................. 3-8 Table of Contents, cont'd SW6 VGA Audio Switcher ii SW6 VGA Audio • Table of Contents Appendix A • Reference Information ...............................A-1 Specifications ...............................................................................A-2 Part Numbers ...............................................................................A-5 Included parts ....................................................