Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Push Open/Close 3. Standby/On (Alarm Off) Indicator LED 4. Standby/On (Alarm Off) Button 5. Stop Button 6. Play/Pause Button 7. Program Button 8. Sleep Button 9. Repeat Button 10. CD Display Button 11. Clock Adjust Button 12. Skip Forward / Clock Set (Hour) Button 13. Skip Backward / Clock Set (Minute) Button 14. Snooze Button 15. Program Indicator 16. FM ST. Indicator 17. Dial Scale & Pointer 18. Sleep Indictaor 19. Repeat Indicator 20. LED Display 21. Phones Jack (at the back) 22. AC Cord (at the back) 23. Music / Buzzer Switch 24. Alarm 2 Switch 25. Alarm 1 Switch 26. Tuning Control 27. Volume Control 28. Function Switch (AM/FM CD) 29. FM Antenna (at the back) 1 2 3 4 5 7 6 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 PREPARATION FOR USE PREPARATION FOR USE Remove the stereo carefully from the box, retaining the packaging for future use. Read these instructions carefully before use. AC POWER OPERATION Unravel the AC cord and connect it to a convenienty located AC outlet. Press the STANDBY button to switch the unit on or off. The Clock Display will show 12:00 and needs to be set. If the AC cord is disconnected or if there is a power failure, the electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, slide down the A C O u tle t AC Plu g compartment cover at the back of unit) to open. Then, connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended) and slide the battery compartment cover back into place. 9V Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting it again 2 or 3 minutes later. The preset times should continue operating. If the clock resets to 12:00 on the Clock Display, it indicates the battery is dead or not connected properly. BATTERIESPRECAUTIONS Follow these presautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. 3. If the device is not to be used for a long period of time, remove the batteries to prevent injury from possible battery leakage. LISTENING TO THE RADIO OPERATION . Press the STANDBY/ON button to turn the unit on, the STANDBY/ON LED indicator will light. . Silde the FUNCTION switch to the desired band (AM or FM) and tune a station by turning the TUNING control. . When a strong FM stereo signal is received while listening to FM, the FM ST indicator will light and the sound will be heard in stereo. . Adjust the VOLUME control as desired. ANTENNA For FM reception there is a built-in one-meter FM aerial wire at the rear of the unit. Unravel the wire and move it around to obtain the best reception. For MW reception the signals are picked up through the built-in ferrite antenna. You may have to move the unit to obtain the best reception. 2 IMPORTANT IMPORTANT Since movement of the CD mechanism and the sensitive circuitry may cause interference to a radio tuner nearby, switch this unit off while operating other radio devices. This product utilizes a laser Danger -Invisible laser radiation when opened and interlock failed or defeated. Avoid direct exposure to the beam. Caution Use of controls, adjustments, or procedures not listed in this manual may result in hazardous radiation exposure. CONCERNING COMPACT DISCS Only compact discs identified with this mark can be used with this player. HANDLING COMPACT DISCS To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it carefully by the edges. Fingerprints and dust should be carefully wiped off the discs recorded surface with a soft cloth. Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris so gently wiping with a soft cloth should remove most particles. Wipe in a straight line from the inside to the outside of the disc. Small dust particles and light stains will have absolutely no effect on reproduction quality. Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to clean compact discs. These chemicals can damage the disc.s surface. Discs should be returned to their cases after use. This avoids serious scratches that could cause the Laser pickup to skip. Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods. Long exposure to high temperatures can warp the disc. Do not stick paper or write anything with a ballpoint pen on the label side of the disc. 3 LOADING AND UNLOADING COMPACT DISCS LOADING AND UNLOADING COMPACT DISCS LOADING AND UNLOADING COMPACT DISCS . Press the STANDBY button to turn the unit on. . Slide the FUNCTION Switch to the CD position. . Press the right side of the CD door, labelled PUSH OPEN/CLOSE to ...