Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
For improved reception, alter the position of the appliance in radio mode. - 9 IB_KH2201_02_AR909_UK_4.qxd 12.11.2007 13:10 Uhr Seite 10 Setting the time Whilst holding the button TIME o pressed down: 1. Press several times consecutively, or press and hold, the button HOUR i, to set the hours. 2. Release the button HOUR i, as soon as the desired hours setting is shown in the Display t. 3. Press several times consecutively, or press and hold, the button MIN a, to set the minutes. 4. Release the button MIN a, as soon as the desired minutes setting is shown in the Display t. The set time is automatically accepted as soon as the TIME button ois released. Setting the alarm time If the clock is set correctly, as described above: 1. Switch the radio off: Place the volume controller VOLUME / BUZZ g to BUZZ (a »Click« is audible). Whilst holding the button ALARM u pressed down: 2. Press several times consecutively, or press and hold, the button HOUR i, to set the hours. 3. Release the button HOUR i, as soon as the desired hours setting is shown in the Display t. 4. Press several times consecutively, or press and hold, the button MIN a, to set the minutes. 5. Release the button MIN a, as soon as the desired minutes setting is shown in the Display t. The adjusted alarm time will be automatically accepted as soon as the button ALARM u is released. 6. To activate the alarm time function, place the switch lALARM On/Off to “ON”. - 10 IB_KH2201_02_AR909_UK_4.qxd 12.11.2007 13:10 Uhr Seite 11 Snooze Function Pressing the SNOOZE e button interrupts the alarm tone for 8 minutes. After these 8 minutes, the alarm tone is repeated. Place the switch lALARM On/Off to “OFF“ to completely switch off the alarm function. Projection Attention! When used properly, the radiation from the projection of the display is not at all dangerous! However, avoid looking directly into the light beam and do not aim the beam at other persons or at animals. To display the correct time on the wall or the ceiling, the hinged projection element must be swung forwards and the room must be appropriately darkened. 1. Place the switch Projection On/Off k to position ON. 2. Set the projection element as desired. The time is projected onto the required position. Projection distance approx. 40cm - 3m. 3. Adjust the clarity of the projection with the projection focus d. Background lighting for the display and projection Pressing the button Projection/Display Illumination r activates the display illumination and the time projection for approx. 10 seconds. Cleaning • Keep the appliance and the ventilation openings clean at all times. • Fluids may not, under any circumstances, penetrate into the interior of the appliance. • Use a soft cloth to clean the appliance housing. • Never use detergents or solvents that could damage plastics. - 11 IB_KH2201_02_AR909_UK_4.qxd 12.11.2007 13:10 Uhr Seite 12 CE- Conformity This consumer electronics appliance, being in conformity with their fundamental requirements and directions, complies with the relevant regulations of both the EMC Guidelines 2004/108/EG and the Guidelines for Low Voltage Appliances 2006/95/EG. Disposal Do not dispose of the appliance in your normal domestic waste. This appliance is subject to the European Guidelines 2002/96/EG. Dispose of the appliance through an approved disposal centre or at your community waste facility. Observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. Disposing of batteries! Do not dispose of the batteries with household waste. Every consumer is obliged by law to deposit all batteries at a collecting point of his community/his precinct or to return them to a shop. This obligation is intended to ensure that batteries are disposed of in an environmentally safe fashio...
Dieses Handbuch ist für folgende Modelle:Time Clocks - KH 2001 (624.12 kb)
Time Clocks - KH 2202 (624.12 kb)
Time Clocks - KH 2202 (624.12 kb)