Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: AT&T Dateigröße: 2.19 mb Dateiname: cl83401_QSG_i1.pdf Unterrichtssprache:

Excessive moisture. Extremely low temperature. Mechanical vibration or shock such as on top of a washing machine or workbench. Telephone base and charger installation Install the telephone base and charger as shown below. Telephone base installation Plug the large end of the power adapter into a power outlet not controlled by a wall switch. Plug one end of the telephone line cord into a telephone jack or a DSL filter. If you have DSL high-speed Internet service, a DSL filter (not included) is required. Telephone line cord Route the power adapter cord through this slot. Route the telephone line cord through this slot. Raise the antenna. Plug the other end of the telephone line cord into the telephone jack on the back of the telephone base. Plug the small end of the telephone base power adapter into the power adapter jack on the back of the telephone base. Charger installation Plug the power adapter into an electrical outlet not controlled by a wall switch. IMPORTANT INFORMATION Use only the power adapter(s) supplied with this product. To order a replacement power adapter, visit our website at or call 1 (866) 288-4268. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet. Battery installation and charging Once you have installed the battery, the screen indicates the battery status. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 10 hours of continuous charging. NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute. Step 1 Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. Insert the supplied battery with the label THIS SIDE UP facing up as indicated. Step 2 Align the cover flat against the battery compartment, then slide it upwards until it clicks into place. BY 1021BT183342/BT283342 CHARGE light Step 3 Charge the handset by placing it face forward in the telephone base or charger. The CHARGE light on the top of the handset is on during charging. After you install your telephone or power returns following a power outage, the handset will prompt you to set the date and time. For instructions, see Set date/time on page 8. To skip, press OFF/CANCEL. IMPORTANT INFORMATION Use only the supplied rechargeable battery or replacement battery (model BT166342). To order, visit our website at or call 1 (866) 288-4268. If you do not use the handset for a long time, disconnect and remove the battery to prevent possible leakage. Quick reference guide - handset pDIR/VOLUME Press pDIR to show directory entries when the handset is not in use. Press to scroll up while in menus. While entering names or numbers, press to move the cursor to the right. Press to increase the listen...

Herunterladen

Geben Sie zwei Ziffern: