No Power No Problem Alarm System . Triple time display: A main display for the clock and two sub-displays for the alarms . Nap Timer (Count Down Timer) . Extendable Snooze time from 10 to 60 min Precautions . Use the power source specified in “Specifications” to operate the unit. . The name plate indicating operating voltage, etc. is located on the bottom of the AC power adaptor. . To disconnect the power cord (mains lead), pull it out by the plug, not the cord. . .................................................Do not carry the unit by the FM/DAB wire antenna and the AC power cord. . Do not leave the unit in a location near a heat source such as a radiator or air duct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. . Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, blanket, etc.) or near materials that might block the ventilation holes such as a curtain. . Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. . When the casing becomes soiled, clean it with a soft cloth dampened with mild detergent solution. Never use abrasive cleansers or chemical solvents, as they may mar the casing. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Troubleshooting Should the problem persists after you have made the following checks, consult your nearest Sony dealer. The clock flashes “AM 12:00” due to a power interruption. . The battery is low. Replace the battery. Remove the old battery and install a new one. The CD, DAB, FM, or buzzer alarm does not sound at the preset alarm time. . Hasn’t “ALARM A” or “ALARM B” in the display gone out? The CD, DAB, or FM alarm is activated but no sound comes on at the preset alarm time. . Has VOLUME been adjusted ? The CD player does not operate./ ”00” flashes in the display for 5 seconds even though a CD is inserted. . Did you close the CD compartment lid? . Did you insert the disc correctly? The disc should be inserted with the label side up. . Dusty or defective disc — Clean the disc with an optional cleaning cloth. Wipe the disc from the center out. . Take out the CD and leave the CD compartment open for about an hour to allow condensation to evaporate. Sporadic loss of sound during CD operation. . Dusty or defective disc — Clean or replace the disc. . Excessively high volume — Reduce the volume. . Strong vibration. . There are scratches on the CD surface..Insert another CD. No sound comes from the speakers. . Has VOLUME been adjusted ? Specifications CD player section System: Compact disc digital audio system Laser diode properties: Material: GaAlAs Wavelength: 785 – 800 nm Emission duration: Continuous Laser output: Less than 44.6 .W (This output is the value measured at a distance of about 200 mm from the objective lens surface on an optical pick-up block with a 7-mm aperture.) Number of channels: 2 Frequency response: 20 – 20 000 Hz +1–2 dB Wow and flutter: Below measurable limit Radio section Frequency range: FM: 87.5 – 108 MHz DAB (Band-III): 174.928 (5A) - 239.200 (13F) MHz DAB (Band-III) frequency table (MHz) No. Channel Frequency 1 5A 174.928 2 5B 176.640 3 5C 178.352 4 5D 180.064 5 6A 181.936 6 6B 183.648 7 6C 185.360 8 6D 187.072 9 7A 188.928 10 7B 190.640 11 7C 192.352 12 7D 194.064 13 8A 195.936 14 8B 197.648 15 8C 199.360 16 8D 201.072 17 9A 202.928 18 9B 204.640 19 9C 206.352 20 9D 208.064 21 10A 209.936 22 10B 211.648 23 10C 213.360 24 10D 215.072 25 11A 216.928 26 11B 218.640 27 11C 220.352 28 11D 222.064 29 12A 223.936 30 12B 225.648 31 12C 227.360 32 12D 229.072 33 13A 230.784 34 13B 232.496 35 13C 234.208 36 13D 235.776 37 13E 237.488 38 13F 239.200 Antennas: FM/DAB: FM/DAB wire antenna General Time display: 12-hour system Speaker: 50 mm diam., 8 ., cone type (2) Input: Built-in audio cable with stereo-mini plug (1): minimum input level 245 mV, impedance 47 k. Power outputs: 1 W + 1 W (at 8 ., 10% harmonic distortion) Power requirements: 230 V AC, 50 Hz For power backup: 3 V DC, one CR2032 battery Dimensions: Approx. 170 . 136 . 204 mm (w/h/d) incl. projecting parts and controls Mass: Approx. 1 700 g incl. CR2032 battery Design and specifications are subject to change without notice. Initial Setting for the Clock This unit is preset to the current date and time at the factory, and is powered by the back up battery. 1 Plug in the unit. The current time appears in the display. Note Though the clock is correctly set at the factory, discrepancies may arise during transport or storage. If necessary, set the clock to the correct time by referring to “Setting the Clock Manually” or “Setting the Date Manually”. When daylight saving time (summer time) begins This model automatically adjusts for daylight saving time (summer time). “” is displayed from the beginning of daylight saving time (summer time) and disappears at the end...

Dieses Handbuch ist für folgende Modelle:
- ()