Stimmen - 3, Durchschnittliche Bewertung: 4.7 ( )

Hersteller: Philips Dateigröße: 305.3 kb Dateiname: Unterrichtssprache:

Press REPEAT ALARM/SLUMBER OFF® With this switch you temporarily switch off the alarm. -After 7 minutes the alarm (radio, or buzzer) will sound again. - If you press REPEAT ALARM/SLUMBER OFF ® again, the same will happen. - If REPEAT ALARM/SLUMBER OFF is not pressed again, the alarm will switch itself off after 59 minutes. The following day the alarm signal will sound again at the set alarm time. Switching off the alarm for 24 hours • Press the ALARM RESET button ©. -The alarm is now switched off for 24 hours and will sound again the next day at the same time. Switching off the alarm completely • Set the ALARM switch © to OFF. - On the display the ALARM indicators will disappear and the alarm is now switched off. • If you wish to be awakened the following day again, you must reset the ALARM © switch to 1, 2 or 1+2 before going to sleep. 6 SLUMBERING ADDITIONAL INFORMATION SLUMBERING_ -The clock radio has a built-in slumber function. With this function you can continue to listen to the radio while falling asleep. You do not need to switch off the radio yourself. This happens automatically. The period during which you continue to listen to the radio is called the slumber time. You can set this yourself. The maximum slumber time is 59 minutes. Slumber time • If you wish to slumber for 59 minutes, you should simply press the SLUMBER button ©. -As long as you press the button, the display will show a slumber time of 59 minutes. • If you wish to slumber for less than 59 minutes, then keep SLUMBER button ® depressed. -The display will now slowly begin to count down from 59 to 00 minutes. • As soon as the required slumber time is reached, release the button. Slumber off You can switch off the radio before the slumber time has elapsed: • Press REPEAT ALARM/SLUMBER OFF ® and the radio is switched off. NOTE: - The slumber function will not operate if RADIO switch :D is ON, because the radio will then simply stay on -The slumber function has no influence on the alarm setting. - During slumbering the radio is often on very low. Bear this in mind if you wish to be woken the next day, as you will perhaps sleep through the sound of the radio. NIGHTLIGHT_ • Press the NIGHTLIGHT ON/OFF button ij> to switch the nightlight on and off. -When this button is in the OFF position the nightlight will also light up when the alarm sounds. When the alarm stops the nightlight goes out. • Press the NIGHTLIGHT HI/LO button ® to select the desired brightness of the nightlight. MAINS VOLTAGE_ Power breakdown -As soon as the power fails, the whole appliance will be switched off. -When the power returns, the figures on the display will begin to blink. The clock radio is thereby indicating that you must set the correct time and alarm time. Battery • You may fit a 9 volt battery in the clock radio. If the power then fails, the clock will in any case continue to operate. This will not however be visible, because the battery does not power the lighting of the clock display. As soon as the power returns the display will show the correct time. To be perfectly clear: Alarm, radio and display do not operate on the battery. • Insert the battery into the compartment in the base of the appliance (see illustration). Recommendation • Replace the battery once a year. It cannot be stated precisely how long the battery will last. This depends completely on how often and for how long the power fails. This may vary from country to country or even region to region. • If you will not be using the appliance for any length of time, then it is advisable to remove the battery from the appliance, to avoid the possibility of leakage and consequently damage to the appliance. 7 English English <§D ADDITIONAL INFORMATION MAINTENANCE_ - If you do not intend to use the clock radio for a long time, it is better to remove the plug from the wall socket. In addition to this, it is advisable to > remove the battery from the clock radio. This will prevent any danger of leakage and the clock radio will not be damaged. - Fingerprints, dust and dirt on the clock radio should be removed using a clean and damp soft cloth or chamois leather. When cleaning do not use any products wich contain abrasive agents or solvents (benzine, thinner, alcohol etc.). These might affect the housing. - Rain, dampness and extreme heat may damage the clock radio. For this reason it should not be placed in full sun or close to heating elements for any period of time. The type plate is located on the base of the set. This product complies with the radio interference requirements of the European Community TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE REMEDY -No sound -The volume is not set to the proper level - The setting of the ALARM switch ,5 is incorrect • Turn VOLUME @ to adjust the sound level. • Set the ALARM switch •'1' properly - Broadcast cannot be received. - Insufficient antenna input • Rotate the set for best reception - In FM mode cr...

Herunterladen

Geben Sie zwei Ziffern: