Stimmen - 2, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Release the ALARM button to return to current time. Icon “AL” disappeared. WAKE TO RADIO 1. Set the FUNCTION Selector to “RADIO” and Power on the unit. 2. Select the band, station, and volume level that you wish to hear when the alarm comes 'On'. S 3. Set the FUNCTION Selector to “AUTO”. The ALARM Indicator will light up. 4. Reconfirm the wake up time settings by pressing the ALARM button. 5. The radio will turn 'On' at the selected wake up time. Icon “Z z” will blink while the alarm sounds. 6. To stop the radio, press the ALARM button. The radio will stop but the alarm remains set and will turn the radio on again at the same time on the following day. 7. If you do not want the alarm to turn the radio on the following day, set the FUNCTION Selector to the 'RADIO' or ‘CD” position. WAKE TO BUZZER 1. Set the FUNCTION Selector to the “AUTO”. The ALARM indicator will light up. 2. Set the BAND Selector to “AL”. 3. At the selected wake up time the buzzer will sound. Icon “Z z” will blink while the alarm sounds. The Buzzer will sound for 1 minute and stop but the unit remains on. Icon “Z z” stops flashing. 4. If you want to listen to the radio after wake up, set the BAND Selector to “FM” or “AM”. 5. To stop the buzzer, press the ALARM button. The buzzer will stop but the alarm remains set and will turn the buzzer on again at the same time on the following day. 6. If you do not want the alarm to turn the buzzer on the following day, set the FUNCTION Selector to the 'RADIO' or ‘CD” position. SNOOZE ALARM After the radio or buzzer alarm sounds, you may press the SNOOZE button for a few more minutes sleep. The alarm will stop for approximately 4 minutes and then turn on again. E-8 TIPS ON USING YOUR FOG-RESISTANT MIRROR TIPS ON USING YOUR FOG-RESISTANT MIRROR 1. Never use alkaline (caustic), alcohol or other organic cleaning agents to clean the mirror surface since this will cause permanent damage to the mirror. 2. Never use an abrasive cloth or paper to clean the mirror surface. This may damage the surface and adversely affect the life of the fog-resistant coating. 3. The fog-resistant mirror is designed to minimize condensation on the surface under normal, warm shower conditions. However, under extremely or humid conditions, some condensation is unavoidable. 4. Should water condense on the mirror surface, clean it with a soft lint-free cloth only. CARE AND MAINTENANCE 1. Clean this unit with a damp (never wet) cloth. Solvents or detergents should never be used. 2. Avoid leaving this unit in direct sunlight or in hot or dusty places. 3. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. 4. If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at all, its bottom surface may require cleaning. Before playing, wipe the disc from the center outwards with a good soft cleaning cloth. 5. Your unit has rubber seals to minimize the risk of moisture getting inside. However, do not immerse it in water since permanent damage to the electrical and mechanical parts will result. 6. Always clean the outside of the cabinet thoroughly if it becomes wet with moisture or water splashes. This will help to prevent the internal parts of the unit from entry of water and possible moisture damage. E-9 TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE If you experience difficulties in the use of this music system, please check the following or call 1-800-777-5331 for Customer Service. Symptom Possible Cause Solution Can not turn unit on Function selector is set to AUTO Set Function Selector to RADIO or CD Noise or sound distorted on AM or FM broadcast. Station not tuned properly for AM or FM. Retune the AM or FM broadcast station. Reposition the unit until the best reception is obtained. No AM or FM sound. The unit is not in AM or FM function mode. Volume at minimum Set function selector to AM or FM. Increase volume CD player will not play Unit not in CD function mode. CD is installed incorrectly. It the CD is self-compiled, the media used may not be compatible with the player. Weak Batteries Select CD function mode. Insert CD with label side up. Use better quality blank media and retest. Replace all batteries. CD skips while playing Disc is dirty or scratched. Wipe CD with clean cloth or use another disc. Intermittent sound from CD Player Dirty or defective disc Dirty pick up lens Player is subject to excessive shock or vibration Clean or replace the defective disc Use a CD-lens cleaning disc to clean the lens Relocate the player away from shock or vibration No Snooze function Alarm duration (1 minute) has elapsed. Press the SNOOZE Button while Icon “Z z” blinks. SERVICE Please refer to the instructions on the enclosed warranty card for returning your unit for service. When returning the unit, please remove batteries to prevent damage to the unit in transit and/or from possible battery leakage. We are not responsible for batteries returned with the pr...