Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
These limits provide reasonable protection against radio and TV interference in a residential area. However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate interference you can try one or more of the following corrective measures: • Reorient or relocate the receiving antenna. • Increase the distance between the equipment and the radio or TV. • Use outlets on different electrical circuits for the equipment and the radio or TV. Consult your dealer or an experienced radio/television technician if the problem still exists. Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s warranty and void your FCC authorization to operate it. This Class B digital apparatus complies with Canadian ICES-003. Maintenance • Place the unit on a level surface away from sources of direct sunlight or excessive heat. • Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture. • Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzene, thinner or similar materials can damage the surface of the unit. Quick Start Quick Start 2:inserts Select the dock insert for your iPod model from the table below and place insert in dock. Never dock an iPod without an insert in place. 3:iPod Insert iPod into dock with proper insert (iPod must not be in a skin or case). iPod will charge while docked. Press the Play Button on the iH120 to play iPod. 1:power Attach AC adaptor cable to DC jack on back of the iH120 and plug the other end into a wall socket. nano 4G insert 17 nano 4G thin iPod with video (30 GB) Insert 9 thin (30 GB) iPod with video thin (80/120 GB) iPod classic iPod touch 2G iPod touch 2G insert 16 For this iPod Use this insert NOTE: If you do not have an insert for your iPhone/iPod, please visit or call iHome toll free at 800-288-2792 to purchase one. Controls and Indicators Controls and Indicators Top panel << Button Alarm-1 Button Alarm Reset / Power Button Wake-to Button iPod Dock iPod Play/Pause Button >> Button Alarm-2 Button Volume + Button Volume - Button Sleep Button Snooze/Dimmer Button Front panel Back panel Time Zone Button Clock Adj Button DST Switch Line-in JACK 2 iH120 Display iH120 Display Alarm 1 Indicator Alarm 2 Indicator iPod Indicator Daylight Saving Time Indicator Wake-to Indicator Battery Low Indicator Wake-to Buzzer Indicator PM Indicator Time Display (PM) Alarm Time Indicator Alarm Time Indicator Sleep Indicator Install Clock Backup Batteries The iH120 uses 2 alkaline “AA” batteries to provide continuous alarm operation and clock settings in the event of a power failure. If the backup batteries have been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings. 1. Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement. 2. Open backup battery compartment door located on the bottom of the unit. 3. Insert 2 AA batteries, checking that the polarity (+ and – ends of the battery) matches the drawing near the battery compartment. Close the compartment door. Note: Make sure you dispose of batteries properly (see your local regulations). Installing Backup Batteries 3 Using the Optional Remote Control Using the Optional Remote Control Remote not included with all iH120 models. To order a remote, please visit Power Button turns unit OFF or Reset Alarm. Volume Buttons raise and lower volume on the unit. Pressing FWD/REW while iPod is inserted will FWD/REV to next/previous track Pressing and holding FWD/REW while iPod is docked will scan forward/reverse within currently playing track. Pressing Play/Pause from power off mode will play iPod. Pressing Play/Pause while iPod is docked and playing will pause iPod. Press again to resume play. Pressing the sleep mode function same as on main unit. Pressing the mute button will mute unit. Pressing the snooze/dimmer mode function same as on main unit. Install/Replace the Remote Control Battery Install/Replace the Remote Control Battery The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time to replace the battery with a new one. 1. The battery door is located on the back end of the remote control. 2. Pull the battery door to release the battery door latch and take out the battery. 3. Insert a CR2032 battery, checking that the + and – sides of the battery matches the drawing inside the battery compartment. 4. Replace the battery door. Installing Remote Battery Note: Make sure you dispose of batteries properly (see your local regulati...
Dieses Handbuch ist für folgende Modelle:Radios - iH120 (167.25 kb)