Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
13 Customer service ................................................................................................. 13 Warranty ..................................................................................................................... 14 Limited warranty................................................................................................... 14 Product Information .................................................................................................... 15 Features................................................................................................................ 15 Size ....................................................................................................................... 15 January 7, 2002 AM149204_02_V.pdf Unpack the carton (see Figure 1) Unpack the carton (see Figure 1) ® radio if any part appears damaged. Instead, repack the carton and notify Bose® or your authorized Bose dealer immediately. Place the Wave® radio on a table or other flat surface. Locate the FM and AM antennas, the power cord, and the AA batteries. Remote control Wave® radio AA batteries Lithium battery ® ACOUSTIC WAVE RECEIVER REMOTE CONTROL AWRC-1 PRESET STATIONS STA. 1 2 3 64 5 MUTE TIME ALARM SLEEP AUX AM FM TUNING VOLUME Power cord FM antenna Peel-andstick tape AM antenna clip AM loop antenna Install the batteries The Wave® radio’s three AA batteries maintain its memory and backup alarm system for up to a week during a power failure, or while the radio is unplugged. The batteries will not power the radio or light the display. Operating without batteries leaves the memory unprotected, but will not harm the radio. Use only 1.5V AA alkaline batteries (IEC-R6 in Europe), available at many retail stores. 1. Carefully turn your Wave® radio upside down (avoid scratching its top). 2. Locate the battery compartment on the bottom (see Figure 2). 3. Press the arrow on the cover to slide the compartment open. 4. Place the batteries inside, matching the + and – symbols with the symbols inside the compartment. 5. Slide the cover back into place VARIABLE OUT LR AUX IN 120V~AC 50-60HZ 50W 172087 + +– and turn the radio right side up. Setting Up Figure 1 What comes with your Wave® radio. • One (1) Wave® radio • One (1) power cord • Three (3) AA batteries • One (1) FM antenna • One (1) AM antenna • One (1) AM antenna clip • One (1) peel-and-stick tape • One (1) remote control • One (1) lithium battery Figure 2 Match the + and – symbols on the batteries to the marks inside the compartment. AM149204_02_V.pdf January 7, 2002 Setting Up Setting Up Find the jacks on the back of your radio (see Figure 3). Unwind all cords. Connect the power cord 1. Plug the small end of the power cord into the power jack. 2. Plug the other end of the power cord into an electric outlet. The display panel should light up. Connect the antennas 1. Plug the FM antenna into the “FM 75. External” connector. 2. Plug the AM antenna into the “AM LOOP” jack. 3. Straighten both antennas. Move the AM loop and ends of the FM antenna as far as possible away from the radio. 4. Use the clip and peel-and-stick tape to attach the AM loop antenna to a smooth, clean surface, if you wish. 120V~AC 50-60HZ 50W R L AUX IN AM LOOP172087 VARIABLE OUT Peel-andstick tape clip Note: The time display will begin to flash after power is connected. Press the CLOCK SET key once to stop the flashing. Note: A second FM antenna is built into the power cord. For best reception, adjust the antenna by moving the power cord. Figure 3 Plug the antennas and power cord into their jacks. January 7, 2002 AM149204_02_V.pdf The remote control Install the battery The remote control Install the battery ® radio has a security lock. It must be unlocked before you open the compartment to insert or remove the battery. 1. Place the remote control face down on a flat surface. 2. Insert the tip of a ball point pen in the left side of the security lock. Push to the right and hold (Figure 4). 3. Slide the battery compartment open. Insert the battery into the battery carrier, matchng the + symbols. 4. Slide the battery compartment closed. It will automatically lock in place. Setting Up Note: Use only a lithium Toshiba CR2025 or Maxell CR2025 battery. It may be available from a retail dealer or electronics store. If you have difficulty finding a replacement battery, contact Bose® Corporation directly (see “Customer service” on page 13). Figure 4 Push the security lock to the right with the tip of a ball point pen. 12 How to operate Aim the remote control at your Wave® radio. The remote normally works up to 20 feet in front of the radio, and 6 feet to either side. Use the remote keys in the same way you use the radio control panel. Replace the remote control battery when it stops operating, or its range seems reduced (normally every year or two). Figure 5 Insert the battery, matching the + symbols. WARNING: The remote control battery may cause a fire or chemical burn if mis...