Stimmen - 4, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
This ultra compact stereo receiver lets you enjoy your favorite radio stations while keeping your hands free for other activities. And you can enter up to 20 of your favorite stations (10 FM and 10 AM) in the tuner memory for easy recall at the touch of a button. Switch on the BBS (Bass Boost) Control and you won't believe you're listening to a system that fits in the palm of your hand. For the fashion conscious we've included two additional color snap-on front panels so you can coordinate your radio with your mood, or whatever you're wearing. Please read this instruction sheet carefully and completely to make sure you understand the operation of your personal stereo receiver, and save this sheet for future reference. If you encounter any problems with the set up or operation of this radio, please call the Emerson Radio Corp. Customer Service Hotline, toll free, at 1-800-898-9020. A Word Of Caution Use good common sense when using this or any other headphone system. Adjust the volume to a comfortable level. Continuous listening to music through headphones at high volume levels can be detrimental to your hearing. Also, do not set the volume to such a high level that it prevents you from hearing other sounds, such as approaching cars, etc. LOCATION OF CONTROLS Visit our web site at Battery Installation 1. Hold the radio upside down and slide the battery compartment door in the direction of the arrow until the door pops open. 2. Insert two ‘AAA’ size batteries (not included), following the polarity diagram shown at right. We recommend using alkaline batteries for longest life. 3. Push the battery compartment door closed and slide it back opposite the direction of the arrow. Memory backup In order to maintain the memories when installing new batteries, the unit must be turned off and new batteries installed within 10 minutes. 1. BAND (AM/FM) Switch. 2. Headphone Jack. 3. TUNING DOWN Button. 4. TUNING UP Button. 5. MEM.CH and Buttons. 6. MEM (Memory) Button. 7. LOCK Button. 8. LCD Display. 9. Battery Compartment. 10. VOLUME Control. 11. POWER ON/OFF Switch. 12. BBS (Bass Boost) ON/OFF Switch. 13. Belt Clip. MODEL: HR2001 AM/FM PLL STEREO RADIO Listening to the Radio 1. Insert the headphone plug into the headphone jack. The headphone wire serves as the FM antenna. 2. Set the VOLUME control to a low setting. 3. Set the BAND selector switch to either the AM or FM position, as desired. Removing The Belt Clip To remove the belt clip, slide it downward in the direction of the arrows. Changing The Front Panel • To remove the front panel gently pry it up from the bottom edge as shown. • To replace the front panel, place it on the front of the radio and press down on the panel at (1) Right side first and then (2) Left side until it snaps into place. 11 12 13 10 3 7 8 9 2 1 4 5 6 NOTE: If the batteries are changed while the POWER switch is 'ON', the display may not reappear immediately. If this occurs, slide the POWER switch to the 'OFF' position, and then back to the 'ON' position to restore the display. 4. Slide the POWER switch to the ‘ON’ position. The display will come on and show either an AM or FM radio frequency, depending upon the setting of the BAND selector switch. Tune to your desired frequency by pressing either the TUNING ‘UP’ or ‘DOWN’ button repeatedly until the frequency of your station appears on the display. If either the TUNING ‘UP’ or ‘DOWN’ button is held for approximately two seconds, the tuner automatically scans up or down to the next strong station and stops on that station. NOTE: If the tuner does not stop on the exact frequency of the station, press either the TUNING ‘UP’ or ‘DOWN’ button again until the exact frequency of the desired station appears in the display. If you are listening to a FM station and that station is broadcasting in stereo, the ‘ST’ indicator will appear in the display. 5. Adjust the VOLUME and the BBS (Bass Boost) controls, as desired. 6. If you are carrying the radio in a backpack, handbag etc. while you are listening, you may press the LOCK button to disable all of the front panel controls. This will prevent the station from changing accidentally if something in your handbag or backpack accidentally presses against the TUNING ‘UP’ or ‘DOWN’ button. When the lock feature is engaged, the LOCK indicator appears in the display. Press the LOCK button again to cancel the lock feature and resume normal operation. 7. When you are finished listening, slide the POWER switch to the ‘OFF’ position to turn the radio off. Remember that just removing the headphones does not turn the radio off. If you do not set the POWER switch to the ‘OFF’ position, the radio remains ‘ON’ even if the headphones are not connected, and the batteries will continue to drain. To Store a Station in the Tuner Memory Up to 20 stations (10 AM and 10 FM) can be stored in the Tuner Memory. 1. Tune to the first station you wish to memorize as described in the previous section. 2. Press the M...