Stimmen - 0, Durchschnittliche Bewertung: 0 ( )

Hersteller: Philips Dateigröße: 1.47 mb Dateiname: Unterrichtssprache:

This Philips baby monitor provides round-the-clock suppor t by ensuring you can always hear your baby clearly without any distracting noise.The DECT technology guarantees zero interference from other wireless appliances and a clear signal between the parent unit and baby unit. Philips Baby Care: taking care together general description (Fig. 1) a Baby unit 1 On/off button 3 2 Temperature sensor 3 LINK light 4 Volume +/– buttons 5 PAGE button 6 Display 7 Nightlight 8 Adapter 9 Play/stop button E 10 Lullaby button K 11 Nightlight button Q 12 Microphone 13 Small plug 14 Batter y compar tment lid 15 Socket for small plug 16 Batter y compar tment B Parent unit 1 Sound level lights 2 Display 3 TALK button 4 MENU button 5 On/off button 3 6 LINK light 7 Recess for the belt clip or neck strap 8 Volume +/– buttons 9 OK button 10 Microphone 11 Loudspeaker 12 Batter y compar tment 13 Belt clip 14 Batter y compar tment lid 15 Neck strap 16 Adapter 17 Charger 18 POWER light C Display 1 Y Room temperature indication 2 QNight light indication 3 K Lullaby symbol 4 T Batter y symbol 5 oVolume indication 6 RMicrophone sensitivity indication 7 U Room temperature above temperature set in menu EngliSh 7 8 I Room temperature below temperature set in menu 9 O‘No connection between units’ message 10 {‘Volume level’ message 11 S Message when lullaby is interrupted D Travel bag important Read these instructions for use carefully before you use the appliance and save them for future reference. , , ,,, , ,,,, , ,, , , , , , Preparing for use This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such. Check if the voltage that is indicated on the adapter corresponds to the local mains voltage before you connect the appliance. Use and store the appliance at a temperature between 10°C and 0°C. The appliance is suitable for mains voltages ranging from 0 to 0V. Do not expose the baby monitor to extreme cold or heat or to direct sunlight. Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/ feet away). Never place the baby unit inside the baby’s bed or playpen. Never cover the baby monitor with a towel or blanket. Never immerse any part of the baby monitor in water or any other liquid. Never use the baby monitor in moist places or close to water. Except for the battery compartments, do not open the housing of the baby unit and parent unit in order to prevent electric shock. Only use the adapter supplied to connect the baby unit to the mains. Only use the charger supplied to charge the parent unit. The adapters contain a transformer. Do not cut off the adapters to replace them with other plugs, as this will cause a hazardous situation. If the adapter of the baby unit is damaged, always have it replaced by one of the original type in order to avoid a hazard. If the charger or the adapter of the charger is damaged, always have the charger replaced by one of the original type in order to avoid a hazard. Always place batteries of the correct type in the baby monitor to avoid the risk of explosion. Always use rechargeable batteries of the correct type for the parent unit. Since continuous transmission is prohibited, you only hear your baby when it makes sounds. Baby unit You can use the baby unit from the mains or on batteries. Even if you are going to use the unit from the mains, we advise you to inser t batteries.This guarantees automatic back-up in case of mains failure. Mains operation 1 Put the small plug in the baby unit and put the adapter in a wall socket. (Fig. ) Battery operation The baby unit runs on four 1.5-volt R6 AA batteries (not included). We strongly advise you to use Philips LR6 PowerLife batteries. Make sure your hands and the unit are dry when you insert the batteries. 1 Turn the battery compartment to the left ( OPEN) with the palm of your hand. (Fig. ) . EngliSh Remove the lid. Insert four 1.5V AA batteries. (Fig. ) Place two batteries on top of each other and make sure the + and – poles of the batteries , point in the right direction. Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ™) withthe palm of your hand to close it. (Fig. 5) Note: When the batteries are running low, the LINK light on the baby unit blinks. Parent unit Mains operation 1 , Put the adapter of the charger in the wall socket and place the parent unit in the charger. (Fig. 6) The POWER light goes on. Battery operation The parent unit runs on two rechargeable 1.2-volt AAA NiMh batteries that are supplied with the appliance. Make sure your hands and the unit are dry when you insert the batteries. 1 Slide the battery compartment lid downwards to remove it. (Fig. 7) Insert the two rechargeable batteries. (Fig. 8) Make sure the + and – poles of the batteries point in the right direction. , Slide the battery compartment lid back onto the back of the parent unit until it locks into position (‘click’). (Fig. 9) P...

Herunterladen

Geben Sie zwei Ziffern: