Stimmen - 5, Durchschnittliche Bewertung: 4.2
(
)
)
|
Anleitung Zusammenfassung
See the corresponding section number for details. Each time you press (MENU), the display will change as follows. The display shows the current channel and group code. <~L /S' 38 * « /S' 38 w fig Ktvi nsa. H 38 v fiSI GECZ oF oF To select the operating channel, see 2-A. To select the group code, see 2-B. To select the VOX sensitivity, see 6-A. To change the call tones, see 3-D. To turn on/off the vibratory call, see 3-E. (KX-TR325 only) To turn on/off the scrambling function, see 5-C. (KX-TR325 only) To select the auto power off mode, see 5-B. E hr When finished, press [TALK] or wait for 10 seconds. • You can exit the programming mode any time by pressing (TALK] or waiting for 10 seconds. The unit has 14 operating frequency channels and 38 group codes. To talk to others, all users in your group must be using the same channel and group code. 2-A Selecting the Operating Channel The factory preset is “1”. o Press (MENU). •» can ” and the current channel will flash on the display. © Press (3 or repeatedly until the desired operating channel (1-14) is displayed. ' 0 When finished, press [TALK 1 or wait for 10 seconds. • The selected code will not be cleared even when you turn off the unit. • To communicate with others without a group code, select “0” (OFF) in step 2. CTCSS code (unit: Hz) No. Freq. No. Freq. No. Freq. No. Freq. 1 67.0 11 97.4 21 136.5 31 192.8 2 71.9 12 100.0 22 141.3 32 203.5 3 74.4 13 103.5 23 146.2 33 210.7 4 77.0 14 107.2 24 151.4 34 218.1 5 79.7 15 110.9 25 156.7 35 225.7 6 82.5 16 114.8 26 162.2 36 233.6 7 85.4 17 118.8 27 167.9 37 241.8 8 88.5 18 123.0 28 173.8 38 250.3 9 91.5 19 127.3 29 179.9 0 OFF 10 94.8 20 131.8 30 186.2 Backlit LCD Display The lighted display will remain on for about 5 seconds after pressing any button except [TALK] or closing the flip. Ear Speaker [TALK] TALK/BUSY Indicator Microphone 3-A Monitor The monitor function activates the speaker. Use this function when received signals are too weak to recognize. You can use the monitor function to check activity on the current channel before transmission. O Press and hold [MONITOR] to open the squelch. •The TALK/BUSY indicator lights green. •You will hear static if the channel is clear for use. 0 Release [MONITOR] to close the squelch. •The TALK/BUSY indicator light goes out. • If you want to use the monitor privately, open the flip before pressing [ MONITOR], 3-B Sending/Receiving Messages O Check the current channel activity (3-A). • Do not talk if someone is already on the channel. 0 Press and hold [TALK] to transmit and talk into the microphone. •The TALK/BUSY indicator lights red. o To receive, release [TALK]. •The TALK/BUSY indicator lights green. •Repeat steps 2 and 3 to continue communication. • To maximize readability of your transmitted signal, pause a few seconds after pressing [TALK], hold the unit 2 to 4 inches (5 to 10 cm) from your mouth and speak at a normal voice level. \? • For safe motor vehicle operation, please do not use the unit while driving. Either stop vehicle or allow passenger to use instead. To select the main speaker volume The factory preset is “5”. O Press (3] or m. •“VOL" and the current volume level will flash on the display. 3-C Private Talk If you want to talk privately during transmission, open the flip. The unit enters the private talk mode. You can transmit by holding the unit near your ear like a telephone handset. o Open the flip and check the current channel activity (3-A). •“ and “VOX” are displayed. •Do not talk if someone is already on the channel. Q Press and hold [ TALK I to transmit and talk into the microphone. •The TALK/BUSY indicator lights red. 0 To receive, release (TALK]. •You can hear the other party’s voice through the ear speaker. •The TALK/BUSY indicator lights green. O When finished, close the flip. •“ and “VOX” will disappear. • To maximize readability of your transmitted signal, pause a few seconds after pressing (TALK) and speak. To select the ear speaker volume The factory preset is “2”. O Open the flip and press (3 or •“VOL” and the...