Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
In order to obtain the best results, please read these instructions BEFORE commencing any work. Please also make a special note of the safety rules and RETAIN FOR FUTURE REFERENCE. Earlex Ltd. will not accept any responsibility for the use of this product, if used for any purposes other than those detailed in this manual. CONTENTS Page 2 Safety Rules Page 3 What’s Included & Set Up Page 4 Preparation & Operation • Filling • Stripping Page 5 Completion & Storage Page 6 Safety Cut Out Other Uses & Trouble Shooting Page 7 Guarantee Page 8 Other Products in the Earlex Range SAFETY RULES - PLEASE READ CAREFULLY Please ensure that you test the plaster before commencing work. If the wallpaper stripper is left attached to the wall for long periods of time (over 10 seconds) it may loosen damaged or blown plaster. SYMBOLS CAUTION Warning: hot liquid or steam can burn. Danger of scalding. Steam may also condense into boiling droplets. Steam should not be directed towards electrical appliances. Danger of scalding appears on the cap as this symbol. DO NOT: • Leave unattended. • Leave steam plate attached to the wall for longer than 10 seconds. This is dependant on the type of wall covering being removed and condition of plaster. Always test on a small area first. • Modify pressure valve supplied. • Stand on the stripper. • Pull by the mains lead. • Point hose or steam plate at anyone. • Allow water or steam to enter light switches or sockets. • Strain or kink hose. • Block the top safety pressure relief valve; it is there for your protection. • Switch off the vacuum whilst the steam plate is attached to the wall/ceiling. • Be careful of overhead water dripping down when working on the ceiling. • When removing Paper/Artex® from ceiling, ensure the steam plate is tilted away from face and body, and regularly check that excessive water is not being retained in the steam plate. When using on the ceiling, remember to empty the waste water tank if it becomes full. • Always use and store upright. • If using on the stairs, ensure boiler is in a safe and secure position. • The unit becomes hot in use. Do not touch. Only move by using the carry handle. • Always wear suitable protective clothing when operating the stripper. • A small amount of water will be expelled from a small hose in the base of the unit onto the surface below. This is to ensure the safe running of the wallpaper stripper and should not be blocked. Protect areas beneath the boiler, likely to be damaged by water or heat by placing the unit on a tray or plastic sheet. • The equipment must be unplugged after use and before cleaning. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Children should be supervised to ensure they do not play with the appliance. • Never remove filler cap or detach hose whilst unit is operating. • Switch off and wait for 2 minutes before removing filler cap to refill boiler. • Allow to cool completely before emptying boiler. • Use only standard tap water. Never use detergents or chemicals. • Extreme care must be taken if the unit is used in bathrooms. Always be aware of danger of electrocution from stored water in baths or sinks. • It is recommended that an RCD (residual current device) rated at 30mA is fitted into the mains supply socket for added protection against electric shock. • Keep equipment away from children and pets. • Use only genuine Earlex replacement parts. 2 3 Please follow these simple instructions to fully assemble your hands-free wallpaper stripper BEFORE use. 1. Remove hoses and Velcro straps from plastic bags. 2. The main hose has two small black tubes coming out of one end. The larger tube (A) is for steam and the smaller tube (B) is for the vacuum. Attach these tubes to the steam plate by inserting through the handle hole. Attach the larger tube (A) to the steam outlet (D), and the smaller tube (B) to the vacuum inlet (C). 3. Once the tubes are connected, clip the hose into the steam plate handle as shown. 4. Use Velcro straps to secure both hoses together. 5. CEILING SET UP Connect the Ceiling Waste Water Drainage Hose to the Waste Water Outlet on the steam plate. Store the Waste Water Outlet Cover (E) in the tube on the steam plate for security. 6. WALL SET UP Store the Ceiling Waste Water Drainage Hose in the tube on the steam plate for security. Ensure the Waste Water Outlet Cover is pushed into the Waste Water Outlet to prevent steam escaping when using the unit on walls. 7. Screw on the other end of the main hose to the boiler, and tighten by hand. 8. Connect the rubber Boiler Vacuum Tube (F) from the the vacuum outlet of the main hose to the vacuum port on top of the unit. 9. Place the end of the ceiling waste water hose into the waste water collection tank. 10. The ...