Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
• When installing the rotary commander, be sure not to damage the electrical cables etc. on the other side of the mounting surface. • Avoid installing the rotary commander where it may be subject to high temperatures, such as from direct sunlight or hot air from the heater etc. Connection Conexion C Master unit Unidad principal B A Heavy duty tape etc. Cinta adhesiva resistente, etc. 5 Choose the exact location for the rotary commander to be mounted, then clean the mounting surface. Dirt or oil impair the adhesive strength of the double-sided adhesive tape. Mark position for the supplied screws. Use the screw holes on the mounting hardware B to mark the positions. If you cannot make the mounting hardware B fit easy; cut the mounting hardware B to fit the steering wheel column cover. Remove the steering wheel column cover, and drill 2 mm diameter holes where you have marked. Warm the mounting surface and the double-sided adhesive tape on the mounting hardware B to the temperature of 20 °C to 30 °C, and attach the mounting hardware onto the mounting surface by applying even pressure. Then screw it down with the supplied screws A. Attach a piece of heavy duty tape etc. on the other side of the mounting surface to cover the protruding tips of the screws so that they will not interfere with the electrical cables etc. inside the steering wheel column. After installing the steering wheel column cover, attach the rotary commander to the mounting hardware by aligning the four holes on the bottom of the rotary commander to the four catches on the mounting hardware and sliding the rotary commander until it locks into place as illustrated. Note If you are mounting the rotary commander to the steering wheel column, make sure that the protruding tips of the screws on the inner surface of the column do not in anyway hinder or interfere with the movement of the rotating shaft, operative parts of the switches or the electrical cables etc. inside the column. After connecting, bundle up the connecting cord of the rotary remote with other connecting cords of the audio equipment by attaching the supplied cramper C. Be sure to leave some slack in the connecting cord between the plug and the cramper as illustrated. Installation Instalacion Holes Orificios Medfoljande monteringstillbehor Material de Montagem Fornecido 1 2 3 4 5 Montering Exemplo de um local para montagem Hal Furos Maskeringstejp eller liknande Fita adesiva, etc. B A Markeringar Marcas B Montering Instalacao Huvudenhet Aparelho principal C Anslutning Ligacao A B C Valj var du vill montera vridkontrollen och rengor ytan. Smuts eller olja minskar den dubbelsidiga tejpens fastformaga. Markera var du ska borra hal for skruvarna. Du kan gora markeringarna utifran skruvhalet pa monteringsdelen B. Om du inte far monteringsdelen B att passa; skar den B sa att den passar holjet som skyddar rattens styrstang. Ta loss holjet som sk...