Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
The Device Select button flashes. 2 Press . to turn on the device. 3 Press any button to control the device. See “Table of Preset Functions” (page 32) for the functions of buttons for each device. If the RM-VLZ620T does not seem to be working . First, try repeating the setup procedure using another manufacturer’s code (if listed for your device). . Try setting the code number using the Search function (page 14). . The remote control signals may be different for some devices or functions. In this case, teach the remote control appropriate signals to the RM-VLZ620T (page 18). To clear a manufacturer’s code setting You can reset the code of any Device Select button to its factory setting. 1 Press and hold SET for more than 3 seconds. The SET indicator lights up. While keeping SET held down, press . 2 Enter 9 - 0 - 2. The SET indicator flashes three times. 3 Press the Device Select button you want to reset. The SET indicator flashes three times and the indicators turn off. To cancel the process, press SET anytime. Notes . When you reset a Device Select button, the learned function or programmed consecutive procedure will also be cleared from the button. . To clear all the settings of the RM-VLZ620T, see page 27. Searching for the Manufacturer’s Code for Non-Sony Devices If you cannot find the manufacturer’s code in the supplied “Manufacturer’s Code List,” set the code using the Search function. Note If no operations are performed for 10 seconds while setting, the setting will be cancelled, and must be restarted. SET/SET indicator9, 2Device Select buttons ., ., . Example: To set the manufacturer’s code for your TV 1 Power on the device with its power switch. 2 Aim the RM-VLZ620T at the device you want to set. 3 Press and hold SET for more than 3 seconds. The SET indicator lights up. While keeping SET held down, press the desired Device Select button, then release both buttons. The selected Device Select button lights up. 4 Enter 9 - 2 - 2. The SET indicator flashes three times to indicate that the setting mode has been entered. 3 flashes 5 Press and hold . to start searching. 6 When the device turns off, release the button. If you overshoot the required code, you can search for the next or previous code using the . or . button. 7 Press . The SET indicator flashes three times, and the indicators turn off. 3 flashes To cancel the process Press SET anytime. Notes . If all codes have been cycled through once, the SET indicator and selected Device Select button flash once and turn off. . If the setting is incomplete, the SET indicator flashes once and the indicators turn off. . If you still cannot operate the device, even after setting the manufacturer’s code using the Search function, another code may be available. Repeat the above steps to search for another code that works for most functions of your device. Checking the manufacturer’s code you have set You can check the manufactu...