Stimmen - 3, Durchschnittliche Bewertung: 3.3
(
)
)
|
Anleitung Zusammenfassung
Miraloma Ave. Anaheim, CA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 techsupport@mounts.com 1. Invert the projector and place it on a soft and flat surface. Remove any foot levelers that might possibly prevent the correct installation of the bracket. 2. Locate the four mounting points located on the bottom of the projector. 3. Line up the mounting points on the projector with the mounting holes on the PDS-017 mounting bracket. WV Premier na Mounts The original holding company 1. Using a screwdriver, secure the PDS-017 mounting bracket using four (4) M4 x 10mm Phillips Head screws. Do not over tighten these screws. Overtightening the screws may result in damaging the threaded inserts on the projector. NOTE: Please refer to the PDS Base Box Installation Instructions to attach the PDS Base Box to the PDS-017 mounting bracket. NOTE: The projector (shown above) is for illustration purposes only. Installation Instructions IN-PDS017.R0 Page 1 LOCK-IT™ Security System WV Premier ni Mounts' The original holding company LOCK-IT™ Security System Premier Mounts 3130 E. Miraloma Ave. Anaheim, CA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 techsupport@mounts.com NOTE: To utilize the LOCK-IT™ Security System, all M6 x 12mm Phillips Pan Head screws (A) must be removed prior to installing the M6 x 12mm Security Screws (D). 1. Remove all pre-installed M6 x 12mm Phillips Pan Head screws (A - 6 total). 2. Use the M5 Security Wrench (B - supplied) to install and tighten the M6 x 12mm Security Screws (D). 3. Using the security wrench (supplied), remove the M6 x 8mm standard set screw and replace it with the M6 x 8mm security set screw (C). 4. Insert the nylon washer (G), 1/4” flat washer (H) and the M6 x 12mm Security Screw (D) into the pivot point (I). 5. Attach bracket to projector using security screws. 6. Once the Phillips Pan Head screws have been replaced with the security screws, re-attach the bracket (E) to the mount (F). 7. Insert the four tilt adjustment security screws (two per side). 8. Follow the instructions in the PDS Manual to complete the installation. Mounting Bracket Security Screws Using a security wrench (supplied), secure the PDS-017 mounting bracket using four (4) M4 x 10mm Security Head screws. Do not over tighten these screws. Overtightening the screws may result in damaging the threaded inserts on the projector. Page 2 Installation Instructions...