Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Toshiba Dateigröße: 4.19 mb Dateiname: Unterrichtssprache:

Notes • The start-up screen will disappear after a moment. You can dismiss the start-up screen before this by performing any operation. You can also configure the start-up screen not to appear via the Display setting menu p.55 . • The first time you use the projector after purchase, after the start-up screen disappears, the Language menu is displayed p.27 . 25 Operations Turning Turning Turning the 1 Press the ON/STANDBY button. A message appears on that you wish to shut off the power. This message will disappear after (This operation is no longer valid after the message disappears.) 2 Press the ON/STANDBY button again. The screen turns off, but the internal cooling fan continues to operate for a short while. Then, the projector goes into standby mode. When cooling lamp During internal cooling After cooling complete FAN TEMP LAMP ON FAN TEMP LAMP ON FAN TEMP LAMP ON (Green) (Green) (Orange) (Off) (Off) (Orange) Flashing (Green) (Off) (Orange) A B C A B During cooling, the LAMP indicator flashes. In this state, the power cannot be turned back on. In addition, unplugging the power cord in this state will shorten the life of the lamp. After the LAMP indicator goes off, the cooling fan continues to operate for a short while, in order to expel excess internal heat. If you are in a hurry, there is no problem with unplugging the power cord in this state. In standby Note • The projector consumes about 6W of power in standby (models equipped with PC card slot consume about 18W). We recommend that you unplug the power cord if you will not be using the projector for an extended period. PRECAUTIONS • Before unplugging the power cord, make sure that the LAMP indicator is off. Unplugging the power cord and cutting off the power while the projector is running or being cooled will shorten the life of the lamp. However, please unplug the power cord if the projector locks up or acts abnormally. • If the power cord was unplugged before cooling was complete, give the lamp sufficient time to cool before plugging it back in. If the lamp overheats it may fail to light, and its lifetime will be shortened. LCD Panels LCD panels wear out. In order to prolong the lifetime of your LCD panel, take the following precautions. • In order to extend the lifetime of the LCD panel, always turn off the power when not in use, and make sure that the lamp is off. Keeping the lamp off is also very effective at saving electricity. • If the air filter becomes dirty and clogged, the projector’s internal temperature will rise, shortening the lifetime of the LCD panel and causing malfunctions. Clean the air filter from time to time p.57 , and replace it periodically. Contact the store where you purchased your projector, or your local Service Station for replacement air filters. 26 Basic Preparations • Place the projector, and correctly connect Remote Control • To operate via the remote PJ MODE] p.20 must be selected. Press the PJ MODE button. The button...

Herunterladen

Geben Sie zwei Ziffern: