Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Andere - Adaptec Serial ATA II RAID 1220SA (181.2 kb)
Andere - Adaptec Serial ATA II RAID 1220SA (29.78 kb)
Andere - Adaptec Serial ATA II RAID 1220SA (196.25 kb)
Anleitung Zusammenfassung
6. Drive Letter may disappear after Medium Error on a Simple Volume On a simple volume with Medium error, the error is reported to the Windows OS. All the error handling is done by the operating system. The expected behavior is intermittent and sometimes drive letter disappear. 7. OS causes invalid data in file copy from Medium Error locations in specific conditions When read medium error occur in simple volume or RAID-0 or a good member of a degraded RAID-1/RAID-10, file copy in Windows Explorer will fail the first few times but will pass on the later attempts; however, the file gets copied has invalid data in the section where the medium error was. This happens because of the Windows OS caching invalid data. 8. To install on to a > 2TB partition, operating systems such as Windows and Linux require a GPT and UEFI environment. The Adaptec HostRAID controller does not support UEFI. Attempting to install to a > 2TB partition may be unsuccessful, depending on the operating system. This includes physical and logical drives. 9. 1220SA controllers may not get detected during POST on some Intel motherboard PCI-e slots. If you do not see the adapter BIOS display during the system POST cycle, power-off the system. Remove power from the system, move the 1220SA to another PCI-e slot, restore power and boot the system. 8. Windows REGISTRY PARAMETERS: 8.1 Driver Specific Registry Parameters WARNING: Altering or adding these driver parameters incorrectly can render your system inoperable. Use them with caution. Follow the instructions below to enter registry values that affect the configuration information for the ADP3132 driver. Note that all HostRAID adapters supported by the installed driver are affected by the values you enter here. The key used for this HostRAID release is "ADP3132". To enter driver-specific parameters, follow these steps: 1) Select Run from the Start button. 2) Type "regedt32" and press Enter. 3) Open the registry list to the following location: Page 2 Relnotes HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\ADP3132 If the \Parameters\Device\ keys already exist, skip to step 6 to begin entering parameters. If the keys do not yet exist, follow steps 4 and 5 to create them. 4) Click on the ADP3132 key. Select "New -> Key" from the Edit menu, type "Parameters" in the "New Key #1" edit box, and press Enter. 5) Click on the Parameters key. Select the "New -> Key" from the Edit menu, type "Device" in the "New Key #1" edit box, and press Enter. To specify a specific host adapter, append Device with the number of the host adapter. For example, type "Device0" for the first host adapter, "Device1" for the second, etc. If you omit the host adapter number, the configuration information will apply to all supported host adapters. 6) Go to the Parameters\Device key. Select "New -> String Value" from the Edit menu, type "DriverParameters" in the "New Value #1" box, and p...