Stimmen - 4, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
FEATURES OF YOUR KAMBROOK ESSENTIALS CAN OPENER 1 2 6 3 4 5 1. Cutter assembly 2.Finger-tip pressure‘On/Off’ control lever 3. Cutting blade 4. Drive wheel 5. Magnetic lid holder 6. Easy grip handle 3 2 USING YOUR KAMBROOK ESSENTIALS CAN OPENER 1. Before use, always ensure that the cutter assembly and magnetic lid holder are correctly positioned (See Fig 1). Fig 1 The cutter assembly fits into the keyhole opening at the top of the Essentials Can Opener, above the drive wheel. Ensure that the post is pushed all the way into the keyhole and that the control lever is pressed firmly against the Essentials Can Opener body. Position the magnetic lid holder up or down until it is in a horizontal position (Fig 1). 2. Insert the two pin plug into a 230/240 volt power outlet and turn the power on. 3. Hold the control lever in the upright position. Position the can under the support bar so that the rim of the can rests on top of the drive wheel, tilting the can at a slight angle towards the main body of the unit (Fig 2). Fig 2 4.Whilst holding the can,firmly press the control lever down, piercing the lid of the can.This holds the can and starts the cutting action. Ensure the magnetic lid holder is in contact with the lid of the can. 5.When the can begins to turn,it is no longer necessary to hold down the control lever. 6.When the can is fully open, the Essentials Can Opener will stop automatically. 7.To remove cans,support the can with one hand and lift the control lever with your thumb on your other hand.The lid will remain attached to the magnetic lid holder (Fig 3). Fig 3 CAUTION : Be careful when removing the lid from the magnet, as the cut edge is sharp. Dented/damaged cans: Occasionally, badly dented cans will cause the Essentials Can Opener to stall. If this happens, grasp the dented can and guide it through the cutting action manually until the damaged areas are open. Jammed cans:To continue opening a can that has become jammed, raise the control lever and release the can. Begin cutting the can again in a new position on the can lip. CARE AND CLEANING Your Kambrook Essentials Can Opener is designed so that the cutter assembly removes for easy cleaning. To ensure best performance keep the cutter assembly clean. Turn the power off and unplug the cord from the power outlet before cleaning. Remove the cutter assembly by raising the lever to its most upright position, and sliding it towards you. Drive Wheel: Wipe with a damp cloth to thoroughly clean; use a small brush to remove accumulated dirt. Motor Housing: Wipe over with a damp cloth. Do not use harsh abrasives or cleaners to clean any parts of your Essential Can Opener, as these may scratch the parts. Do not wash any parts in a dishwasher, as the hot water temperatures and harsh detergents may ultimately warp and scratch these parts. NEVER IMMERSE THE ESSENTIALS CAN OPENER OPEN IN WATER OR OTHER LIQUID. 4 5 Notes KAMBROOK 12 MONTH REPLACEMENT WARRANTY KAMBROOK warrants the purchaser against defects in workmanship and material, for a period of 12 months from the date of purchase (3 months commercial use). Guarantee and purchase receipt for this product are to be retained as proof of purchase and must be presented if making a claim under the terms of the KAMBROOK guarantee. KAMBROOK reserves the right to replace or repair the appliance within the warranty period. Warranty does not apply to any defect, deterioration, loss or injury or damage occasioned by, or as a result of the misuse or abuse, negligent handling or if the product has not been used in accordance with the instructions.The guarantee excludes breakages and consumable items such as kneading blades and mixing containers. This warranty is void if there is evidence of the product being tampered with by unauthorised persons. If the product includes one or a number of accessories only the defective accessory or product will be replaced. In the event of KAMBROOK choosing to replace the appliance, the guarantee will expire at the original date, ie. 12 months from the original purchase date. In Australia, this KAMBROOK Guarantee is additional to the conditions and guarantees which are mandatory as implied by the Trade Practises Act 1974 and State Territory legislation. For service, spare parts or product information in Australia, please call KAMBROOK on the customer Service Line (free call) 1800 800 634. For service, spare parts or product information in New Zealand, please call KAMBROOK New Zealand, Mono Place, Ellerslie,Auckland. Phone 0800 253 007, FAX 0800 263 001. If claiming under this guarantee the product must be returned to freight prepaid. YOUR PURCHASE RECORD (Please complete) Attach purchase receipt here. DATE OF PURCHASE______________________________________________________ MODEL NUMBER ________________________________________________________ SERIAL NUMBER (If applicable) ______________________________________________ Please don’t return purchase record PURCHASED FROM ___________________________...